By having a qualified technician repair the problem the computer has detected with the SRS. open drivers door ... turn key to "ON" position..... within the first 7 seconds while the SRS system is in diagnostic mode... push the dome light switch 5 times, (D/L switch is located at the bottom of the door pillar)This will reset the SRS computer. JB Hey JB, it worked for me as well! I got the SRS light off after pushing the DL switch. Thx! :)
There are a number of reasons why your airbag light has come on or is flashing. We will cover a few explanations that may help you identify where the problem may have originated from. First and foremost if the airbag light is on or flashing, the SRS system is inactive. Therefore, if you get into an accident, the airbag/s will not deploy leaving you unprotected. As you read through the information below suggestions will be provided that may help you solve your airbag light problem.Airbag Battery Backup DepletedA common problem that signals an airbag warning light to turn on or flash, is that your cars battery might have drained recently and the airbag battery backup depleted. This will often correct itself once the battery charge is fully restored. However, depending on your vehicle, you may need a scan tool remove the soft code error that was written to the airbag control module. Airbag Clock Spring Needs ReplacingThe airbag clock spring main function is to maintain continuity with the drivers airbag and the electrical wiring. It maintains continuity by coiling in and out as the steering wheel turns. After many years of use the thin circuit bands my become brittle or worn and cause the drivers airbag to have an intermittent connection. If this occurs a DTC soft code or will be reported to the airbag control module and the airbag warning light will turn on or flash. This is a popular problem on older model vehicles. The only way to determine if your clock-spring is damaged is to have a repair shop diagnose your airbag warning light with a scan-tool. The scan-tool will provide the technician with a DTC code and advise him if the the clock-spring needs replacement. Airbag Module Got Wet or CorrodedA common location for the airbag module in many vehicles is underneath the driver or passenger seat. Therefore, even in light water damaged vehicles the module will short-out or corrode after being exposed to moisture. A shorted module will immediately general a DTC airbag code and your airbag light will flash a warning. The water damaged modules should be replaced as they will often produce unexplained and continued errors.
how to reset a srs warning light on 307 203 model
By having the SRS repaired.
The 'P' symbol in a car sybolizes a warning that your parking break is, or is not on. Depends on your model
depend on year and make of your Vehicle. if late model Ford/Lincoln, it means your driver side "seat belt pretensionor". (There is small bomb in seat belt retractor related with airbag) if early model Ford/Lincoln (and maybe some GM), it means passenger side airbag "System" Don't take it lightly as "Oh, it's just seat belt pretensionor. Airbag still fine". your airbag may not deploy to avoid injured by airbag, if something malfunctioned with pretensionor.
1990 A new Corvette ZR-1 model debuts and a driver-side airbag becomes a standard feature.
how to reset the vigo timing belt warning light
what is a 2006 airbag model honda goldwing gl 1800
Yes , depending on the year and model , there is a fuse in the fuse panel for the blower motor relay + airbag diagnostic monitor . If you re-submit your question with the year and model information I'll try to locate the fuse # for you Helpfull
It depends on where an airbag located as well as brand and model of the car.
It means you have low oil pressure.
depends.... ABS AIRBAG OIL LEVEL OIL TEMP WATER LEVEL WATER TEMP WATER IN DIESEL ECU FAULT depends on car model