0
On that year you can just unhook the battery cable for about 10 mins. BUT if you don't FIX the problem that made it come on in the first place then it will just come back on again.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How to reset ecm in 1995-1997 chevy tahoe with 5.7?
Just unhook the battery cables for 5 mins, That will reset the ECM
What does the ECM 1 fuse control on a 1990 Chevrolet suburban?
Electronic Control Unit or Computer.
What damaged when reverse polarity on a 1990 Chevy truck?
FUBAR the ECM..$$$$$$$
Where is the ecm located on a 1990 Chevy Astro van?
the ecm on this van is on the passenger side behind the plastic kick plate
Where is the ECM on a 1995 Chevy Suburban 7.4L?
Take the inside of the glove box out and look in and down to the right and you will see it.
What does the ecm 1 control on a 1990 Chevrolet suburban?
Emissions controls, fuel/air mixture, timing, and transmission.
Can I put the ECM module from my 1990 Chevy Celebrity wagon into an 86 Chevy Celebrity wagon?
Yes
Where is the reset button on a 1990 Chevrolet Celebrity stationwagon?
I don't know of a "reset button" on a Chevy Celebrity. If you are trying to clear codes on the ECM (engine computer) there are two ways to do it. The easiest way is to pull out the ECM fuse on the fuse block. The other way to clear the ECM codes is to disconnect the battery for a few minutes. Either way have the ignition key in the off position to avoid possible damage to the ECM. Hope this helps.
How do you disconnect the electric from a 97 Chevy Suburban fuel pump?
unplug your ECM B fuse that should shut it off
What could cause a 1999 Chevy suburban not to turnover or start even after I have replaced the battery and starter?
check ecm fuse
Where is the ecm located on a 1991 Chevy Suburban?
Open your glove box and compress the sides or remove the screws at the bottom of it you will find the ECM behind it attached with a metal strap and a 10mm screw.
Reset ecm on a 2000 Chevy silverado 1500?
Disconnect the battry for one hour: then reconnect-That should do it.
