By having the anti-lock brake system fixed. Resetting the light will do no good unless the system is repaired. It will just come back on. I suggest you have this repaired by a qualified tech. You still have standard braking even though the ABS is non-functional.
The brake light is on because there is a problem with the brake system. Until the problem is fixed the light will remain on. Once the problem is corrected the light will reset itself.
Bring to a shop that has an ABS scanner to determine the problem
The ABS light is on because there is a problem with the ABS (Antilock Brake System). Until the problem is fixed the light will remain on. Once the problem is fixed the light will reset itself after a short drive.
If a 1991 Chevrolet S10 Blazer warning brake light always stays on, it could just be a malfunction of the light. To reset it, disconnect the battery for 10 minutes.
How do you reset check engine light for the 2009 Chevy trail blazer?
The ABS light on a 95 S10 Blazer has to be reset by a mechanic or the dealer. Unplugging the battery on the vehicle will not reset the ABS light.
How do you reset dashboard brake light on vw passat
no, you cannot reset the brake maintenance light until you get NEW BRAKE sensors. -Seven11
how do you reset brake warning light 0n 745li bmw
how to reset vw golf brake light
there is no reset on the brake pads, you can check your brake pads sensors they will make the light come on
You can try to reset your brake light switch by unplugging the brake light switch and plugging it back in. If that does not solve your problem you will need to replace the brake light switch.
how can i reset rear brake pad warning light on 2006 bmw 525i
You have a problem with the brake system. Once you repair the problem the light will reset itself.
How do you reset the brake pad warning light for a 2005 c320 mercedes benz?
The transit brake warning light, on a Ford, can be reset by changing the brake pads. If the warning light is still on after changing the brake pads remove the fuse for 10 seconds.
Had brake linings replaced but brake light and check brake lining light will not go out how do I reset.
you have a brake problem and need to have it repaired before you can reset the light sensor you have a brake problem and need to have it repaired before you can reset the light sensor
Replace the brake pads.
Press the reset button
there is a switch up under the brake pedal
One can reset the brake warning light on the discovery 3 by resetting one's brake pads to the original manufacturer's settings and checking if they have been worn through.
There is a problem with the anti-lock brake system. Have the ABS repaired and they will reset the light.
The brake pad sensor light is reset by leaving the key on engine off for about 20sec. If it does not reset retry, if it still does not reset check the wiring of the left front and right rear pad sensors
The ABS light is on because there is a problem with the ABS system. Once the problem is fixed the light will reset itself after a short drive. Your local auto parts store can retrieve the code(s) set in the ABS module to help direct you to the fault.