With the engine off but the key in the "on" position. Open the drivers door and remove the trim panel covering the fuse panel. Toward the top of the fuse display there will be a button labeled "reset". Press this down for several seconds and the car will chime a few times and the "change oil" light will go off. If this doesn't work the 1st time, repeat the sequence.
how do you reset change the oil light in a 2004 alero?
After changing the engine oil, you must reset the system. To reset the system, you must do the following: 1. With the ignition key to ON, push the RESET button located in the driver's side instrument panel fuse block. 2. When the CHANGE OIL light starts to flash, press and hold the RESET button again. The reset is complete when you hear the chimes sound and the CHANGE OIL light goes out. I can e-mail you the manual for the Alero 2001 for 14.95 us forward your payment to paypal send to : ray_rayon@hotmail.com use paypal If you want the Alero use manual on CD then 29.95us
I have a 2002 alero how do you reset, the coolant light is always on. Thanks, Alero owner
To reset the "CHANGE OIL" light, turn the ignition switch to the "RUN" position with the engine off. Fully depress and release the accelerator pedal three times in five seconds. The light will flash twice and go out.
Should reset itself when fluid is added unless sensor is bad
Have vehicle scanned to determine the problem
Reset the change oil light on Mazda 3
You don't. Just and fluid and it will go off.
turn off engine, and start again
Just press the reset button at the fuse panel on the driver side. Press it for some seconds and it will clear the light.
Listed in your owner's manual. However, the reset pushbutton performs two functions. The first function is to find or select the change oil light. The second function is to reset the change oil light. So, when the manual says press the reset pushbutton, it means to press and release, press and release, press and release, ... and so on.... until the change oil light is selected. The change oil light is selected when it begins to flash on and off. Once the change oil light is selected by it flashing on and off, press and hold the reset pushbutton again in solidly to actually reset the light. Hold the reset pushbutton in until the chimes sound. This confirms the change oil light is reset and the light should go out.*Remember* before you even begin resetting using the reset button, the car must be in neutral or park or it will not work.AnswerIf you do not have an oil change reset button located on the drivers side inside the fuse panel. Turn ignition key to the on position (with engine off). Depress accelerator pedal 3 times. Oil change light should blink and you should here a beep, light will go out. Turn ignition key off.
open fuse box on inside of driver door at the top there is a red button while car is switched on not running press and hold button down for about 10 seconds this should reset it