0
On the left side of the drv'r door you will see a fuse panel. open it, turn the ignition to on position, pres the reset button once, the light will start flashing, press and hold the reset button till the light goes out. Note also works for the tire pressure light.
Also if you have been trying other methods, you can reset the codes by disconnecting the negative battery cable then connecting it. Then use the above method. It is in the owners manual
Wiki User
∙ 8y ago
Add your answer:
Earn +20 pts
How do you reset the change engine oil light on a 2000 BMW 528i?
try to reset oil light on 528i bmw year 2000
How do you reset the traction control on a 2000 olds alero?
you cant bad speed senser in one of the wheel bearings is abs light on?
How do you reset the change oil light on a 2000 corvette?
oil servis reset without using a computer http://www.kofla.net/chevrolet.htm
How do you reset tire pressure warning light on the dashboard for 2000 Oldsmobile alero?
My tire pressure light has been on forever. I finally got it to go off by holding in the reset button til it blinked and then shut off. You can try that.. if not it's just gonna stay on.
Reset abs light 2000 Yukon?
how to reset abs warning light on 2000 gmc Yukon
How do you reset change oil light 2000 mustang?
If the change oil light comes on, then a person needs to change their oil. If a person changes their oil the light should turn off.
How do you change the lights on the odometer for a 2000 alero?
very carefully!
How do you reset the oil change light in a 2000 Lincoln ls?
you press the status button. when the oil life indication comes up, hit reset.
How can you reset the service vehicle soon trac off and anti lock lights on 2001 alero?
On my 2000 Alero I open drivers door and open fuse panel door. Then turn key onposition but don't turn engine over. Push in reset button until the light you want flashes then hold the reset button for a few seconds.
When to change transmission fluid on a 2000 Oldsmobile alero?
every 100,000 miles
How do you reset the low tire pressure light on a 2000 alero?
If you open the driver door, on the side of the dash you should see a small removable plastic plate. Pull it off with your finger and inside is a small red reset button, somewhat in the middle. Push it once the oil light should flash, push it again the tire pressure light will flash. Push and hold and it will reset! :) Hope this helps!
How do reset the change the oil light on 2000 GM Yukon?
key on engine off press gas pedal to the floor 3 times wait it will flash and its reset
