Two ways the Check Engine Light (CEL) can be reset: (1) use an OBDII scanner to reset it, or (2) disconnect the NEGATIVE battery cable for about three minutes , then re-connect. The latter will make the engine run rough for a few miles because you will also be erasing information stored in the computer that applies to performance. After a few miles, the computer will "re-learn" and everything will be back to normal. If the CEL comes on again, you definitely need to take the vehicle to Auto Zone or another place that will scan the codes stored in the computer and give you the diagnosis of what's causing the CEL to come on.
ODO
how to reset check engine light on 1992 Mazda mpv
Fix the problem it indicates and reset it by unhooking the battery.
how do you turn off or reset the check fuel cap light on a 1997 Mazda b 2300 2.3 4 cylinder engine.
disconnect the positive battery cable then reconnect.
Go to Advanced Auto. They should be able to.
nothing but take it to Mazda and there computer will reset it, 1hr shop rate..100$ probably a sensor isn't working
Take it to a place that does free check engine light check. Some will reset it after they check it for you. Place in New York State are listed on http://NewYorkForum.us
Have you repaired the problem that cause the light to come on in the first place? If not the light will just come back on. You reset the light with an OBD2 scan tool.
The check engine light is reset with a scan tool after repairing the cause of the fault.The check engine light is reset with a scan tool after repairing the cause of the fault.
The check engine light has to be reset with a OBD scan tool
You reset the check engine light with a scan tool after repairing the failure.