0
How do you reset the computer after changing the turn signal switch?
Wiki User
∙ 14y ago
You do not have to reset the computer after this repair. If the Check Engine Light is on it is not because you made this repair. If you disconnected the battery the computer will reset itself.
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How do you get the computer on a 1998 hombre Isuzu to recognize a new ignition switch?
try removing the negative lead on the battery for about 30 min that will reset your computers
Where is the fuel reset switch on a 1989 dodge caravan 2.5 liter?
Chrysler Corporation does not install inertia switches in their vehicles. It is probable fuel pump, fuse, or relay.
Does the 1996 blazer have an oil safety switch and reset for it?
No, there is no suck switch.
Where is tha kill or reset switch on a 2001 ford mustang that wont start?
If you mean theft system activated, it can only be reset through computer by an auto locksmith or dealer. If light flashes when key is on, theft was detected. If light is not on and you have no fuel at schrader valve on rail- you can try inertia switch for fuel.
Your 2002 Chrysler 300m was in an accident and now wont start is there a inertia switch or cutoff that needs to be reset and where is it?
There is not an inertia switch on this car. The fuel system is computer controlled with relays. So you need to stat with checking for codes, check fuses, etc.
How do you reset computer after changing battery for BMW 745li?
do you have to reset computer after changing battery in 2003 745li
How reset computer after changing battery 2005 BMW x3?
You do not have to reset the computer.
How do you reset computer on Ford Escape after changing battery?
There is nothing concerning the computer that needs to be reset.
Do you reset computer after changing the battery for a 2007 BMW 328 i?
No, you do not have to reset the computer. It will take care of itself.
Do you have to reset the computer after installing a new fuel pump?
no you dont have to reset the computer after changing the fuel pump
After changing battery in 2000 intrepid how do you reset computer?
Not necessary. The computer will reset itself after a few driving cycles.
Where is the reset button for fuel pump on a 2000 Chrysler Sebring?
A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.A Chrysler Sebring does not have a reset switch. The fuel system is computer controlled with relays.
How do you reset computer on a Camry Toyota after changing the battery?
You do not have to reset the computer any more than you reset your computer in your home after a power outage. It will take care of itself.
Do you reset computer on a Camry Toyota after changing the battery?
Yes, you do... But if you do within 1-2 minutes you might not reset the computer.
Do you have to reset the computer after changing an ignition coil on a 99 Firebird?
NO
What is a reset switch?
AnswerA reset switch is to start something totally over. If a water heater stops heating, you can use the reset switch to start it working all over and see if there is a further problem.In computer hardware, which is the category you listed this question in, there is no reset switch on most modern computes. There is a power on/off switch, and you can restart the computer. On some older computers there is a reset button on the motherboard.
Is there a fuel pump reset switch on a dodge ram?
No, dodge doesn't use a reset switch Or inertia switch. The fuel pump is controlled by relays powered by the computer.
