A maintenance light on a Toyota Camry can be reset by your mechanic after you have the work done that is needed. You also may be able to get instructions by checking your manual.
how to reset oil timing on 1990 toyota
how do you reset the low tire pressure warning light on a 2009 camry
The Check Engine Light has nothing to do with oil changes. It is on because the ECU has detected a problem with the emissions system.
how do you reset anti theft on a 1994 toyota camry
i was checking fuses on 1994 toyota camry and airbag light turned on.
you will go to the toyota dearler it good pleace
Replace the bulb that is burnt out.
It is reset with a OBD2 scan tool, after the repair of the system.
You have to find the reason why it came on.
lift the bonnet hey presto
The check engine light is reset with a scan tool after repairing the failure that caused the trouble codes.
use a code reader to check the problem and it will reset the light, but if you do not fix the problem the light will continue to come back on.
To turn off the check engine light on a 1999 Toyota Camry you can disconnect the battery. This will only reset the check engine light. So if there is a persistant problem with the engine, the light is likely going to stay on. To turn off the check engine light on a 1999 Toyota Camry you can disconnect the battery. This will only reset the check engine light. So if there is a persistant problem with the engine, the light is likely going to stay on.
There is no real reset procedure. The problem needs to be diagnosed and repaired, when it is properly repaired the light will turn off by itself
Just disconnect the battery for couple minutes.
Toyota does not use inertia/reset switches.
disconect the negative battery terminal for about 5 min? that's what i do.
No, there is not.
It is important to take care of the issues that have caused the warning lights to turn on. An airbag light can be reset by clearing the code with an OBD scanner.
you need a obd2 compatible scanner to reset the light.you can not do it any other way sorry hth Dave
When a car is being inspected, it cannot have the airbag light on. The light can be reset by an OBDii scanner, that will clear the code causing the problem or by disconnecting the battery for 30+ minutes.
Disconnect the battery for couple minutes, or stop by AutoZone, they can erase it for you for free.
There is no such button.
To reset the check engine light on a 1999 Toyota Camry LE V6, disconnect the positive battery cable for a few minutes. Then reconnect the battery. If the 'check engine' light is still on, then turn the key to on without starting the engine and pump the gas three times and turn the key off. Start the car and the light should be off.