0
Generic answer to "How do I reset the oil change reminder on my late model GM vehicle?"
If your vehicle has a DIC:
-Cycle through display items using DIC buttons (arrow or info)e until oil life remaining% is displayed.
-Press Reset button. If that does nothing, press and hold Reset button for several seconds.
Trucks with menu buttons on steering wheel:
-The buttons on the steering wheel and message displayed on instrument panel should be treated as a DIC. Proceed as above.
Aurora with a little door covering buttons to tell you about fuel usage:
-This is the DIC.
Some vehicles have DIC integrated with Radio or Climate Control controls.
With no DIC:
-Turn ignition lock to off position.
-Verify that door is closed.
-Turn ignition to On/Run position
-Move accelerator pedal from closed throttle to WOT and back to closed three times within five seconds.
-Turn key to off position.
Some N-body cars:
-Locate red "Reset" or "Oil R" inside fuse box located at either left or right end of dashboard visible only with front doors open.
-Turn ignition to On/Run and wait a few seconds.
-Press "Reset" button. Note "Change Oil" light begins flashing. If "Low Tire" light flashes instead, press "Reset" button a second time-a.
-Press and hold "Reset" button for 5 to 10 seconds. You may hear three or five chimes or beeps as confirmation of reset and light should go dark.
Early Saturn with red Reset button in underhood fuse box:
-Turn ignition key to on.
-Press and hold "Reset" button for about 7 seconds.
-Look at dash for blinking oil change reminder lamp.
Some 1990s-ish GM FWD full size cars:
-Look for Reset button or Oil Reset button unside glove box.
-Turn ignition on.
-Press and hold button for about five seconds.
Cadillac without DIC or button in glove box:
-You will need to press and hold 2 buttons on the climate control for about 10 seconds but I can't remember (after) so many years which two buttons they are. Check the manual.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
How do you reset engine light in 2008 buick lucerne?
how do you reset check engine light in 2008 buick lucerne
How do you reset the check engine light on a buick regal?
The check engine light on a Buick Regal can be reset with a special diagnostic scanner. This can be performed at a car dealership or service garage.
How do you reset engine light on 2006 Buick Lacrosse?
Discounted the battery
How Do You Reset Check engine light on 98 Buick Park Ave?
The check engine light on the 1998 Buick Park Avenue can be reset by disconnecting the battery for a few minutes and then reconnecting it. The check engine light is only going to stay off if the problem that created the light is fixed.
How do you reset the security code for a 2006 buick rainer?
Click th reset button on the very bottom of the car
How do you reset the 'Service Engine Soon' light on a 1996 Buick Regal?
You can only reset it with an OBDII diagnostic scaner
How do you reset service engine soon light 2001 Buick century?
with hand held computer (scanner)
How do you reset the service engine soon light for a 2003 buick rendezvous?
Figure out what tripped the code and fix the problem
How do you reset the 'Check Engine light on 2002 Buick Century?
You will need a OBD2 scan tool to reset the light after repairing the problem that caused the fault code. If you do not repair the problem the light will just come back on.
1992 buick park avenue how to reset the Check Engine Light?
After repairing the cause of the code, you can clear it with a scan tool.
How do you reset a service engine soon light on a 1991 buick regal?
Disconnect the negative battery cable for 10 seconds.
How do you reset change oil soon light on 1993 Buick park avenue?
= How do you reset change oil soon light on 1993 buick park avenue? =
