I just reset the service insp on my 98 Passat after trawling the internet for solutions.
The odometer is digital so i only know it works on this type.
Before resetting. It is important to remember that this reminder is displayed because your car is due for a service..!
If you have not recently had the car serviced, or have not booked it in for one, then its a good idea to leave the reminder until you are sure the car is in good working order and does not need an inspection.
Neglect the engine in particular, and it will cost you far more than the price of a service.
1: With ignition off, press the trip reset button on the right under the odometer and hold.
2: Turn ignition on. Don't start engine. Release button.
You should now see "Service Oil" displayed.
3: Press button again. You should see "Service Insp", displayed.
By pressing the button once more it displays "Service Insp" again.
4: Now press and hold the button again with right hand whilst turning the other button "for adjusting the clock", to the right with the other hand.
The display should now change to Service ----.
5: Turn off ignition.
Your Service Inspection notice should now be reset.
If this is not the case then repeat 1-5 but hold the button down once "Service Oil" is displayed.
This advice just saved me 145 Euro at the VW dealership.
What do the flashing words 'service inspection' mean on a 1998 Audi A4 1.9 tdi
You can find the wiring diagram for the stereo of a 1998 Volkswagen Passat in the service manual. It shows what each color wire is used to connect each component and where the wire is routed.
disconnect the battery for 1 minute and it will reset.
VOLKSWAGEN PASSAT 1998-ON 5x112
hold milage reset button in and switch on ignition.hold for about 5 seconds and it will reset.
what does INSP mean? this came out in my 1998 Audi A4 1.8T.
I have a 1998 dodge stratus and the obd inspection results are showing notcomplete or unsupported. I have been told to drive the car so the computer can reset. What is the drive cycle for this car. I have a 1998 dodge stratus and the obd inspection results are showing notcomplete or unsupported. I have been told to drive the car so the computer can reset. What is the drive cycle for this car.
I reset the check engine light on my jeep by disconnecting it from the battery.
You could try un hooking the battery.
6.5"
how i can open back door passat 1998
Disconnect your battery, and leave it disconnected for at least 24 hours. The battery backup on the computer will die after 24 hours, at that point, the service engine indicator is reset.