The airbag light stays on when the computer detects a malfunction and sets a code. The fault needs repaired and the light will shut itself off.
Reset the light. Turn everything off. Turn the key on and off when the light just goes off. Keep doing this several times, the light will reset
Once you have repaired the cause of the light, it will reset itself.Once you have repaired the cause of the light, it will reset itself.
The airbag light stays on when the computer has detected a malfunction and set a trouble code. The light can not be reset until the failure has been repaired.
The light can not be reset until the failure that caused the code is repaired. A scan tool is required to read and diagnose the codes.
By having a professional repair the problem that has set the warning light in the first place.
It can not be reset, failed parts must be replaced.
There isn't one.
If you mean the airbag light. You need to have it checked for codes and repaired by a trained mechanic. The airbag system is not for DIY'ers.
Disconnect the battery. I had a problem with my service soon light coming on very light, not bright and I was told it could have something to do with not closing my gas cap tightly.
For the airbag light to turn off, you'll need to repair the cause of the airbag malfunction, or disable the airbag by using a BMW scan tool or other software.
I found that urinating on the passenger seat works well. You can also try inserting your phallus into the cigarette lighter to cause a short.
The airbag light stays on when the computer has detected a malfunction and set a code. You need to have the system checked for codes with a scan tool and repair the failure. The light can then be reset.
You don't. The light is on because there is a problem and will remain on until the problem is fixed. When the problem is fixed the light will go out by itself. As long as the airbag light is on the airbag won't function if needed. A common problem with an older vehicle is the "clock spring" goes bad. All or some of the electrical items located in the steering wheel like the horn, cruise control and airbag stop working when the "clock spring" fails.
vice & oil reset 2002 sl500
To change the trunk light in a 2002 Nissan Maxima, a person will need to unscrew the cover over the light. Then they can remove the old bulb and replace with a new one. Then screw the lens cover back on.
The air bag light is on because the air bag system has detected a problem with the system. Once the repair is made the system will reset the light itself. One common possibility could be a faulty "clock spring". Take the vehicle to a trusted mechanic for diagnoses.
how do i reset timing belt light on 1hz
The airbag computer has detected a malfunction and set a code. You need to take it in for service with a trained technician. The airbag system is not the place for do it yourselfers.
You would have to take it to a Ford dealership so they could diagnose why the airbag light is on. It is not something that you would want to do yourself.
It is very easy to reset the check engine light on a 2002 Volkswagen Cabrio. The negative battery cable can be taken off for one minute and replaced to reset the light.
You reset the light by taking it to the dealer and having the SRS repaired. Ignore this and either your air bags will not deploy, deploy at the wrong speed, or deploy while you are driving down the road. Get this fixed ASAP, and do not attempt this yourself. Serious injury can occur.
You can't reset that light...there is no such thing as a 2002 Honda Element...they didn't come out until 2003.
This airbag issue is part of a recall by Mazda. You should contact your dealer.