on your steering wheel contols scroll thru the menu until you see the engine oil life and old the arrow key down. that should erase it...
The answer is no.
Read your manual for accuracy, it's n there, but, If I'm not mistaken it's turn your key to ignition and pump the accelorator about three times, that should reset it.
Take this truck to a professional for repair. Working on the SRS is hazardous and is not a DIY repair. Something is wrong with the SRS or the light would not be on.
There are pages and pages of things that can cause a check engine light. You need to have it checked with a scantool. Then the code can be diagnosed and repaired.
On April 1, 2003.
if you have the steering wheel controls, that arrow on the lower right side will reset it.
turn your switch forward but dont crank and press the gas about 4 times and hold for 5 seconds let go turn switch back then start car
There is no reset button for the check engine light. You can have Mitz. do it for $$$ or you can remove the negative battery line for a few seconds and replace. That will reset the check engin light.
AnswerTo reset the change oil soon light turn the key to on (not run) and step on the gas to the floor 3 times fast.ACCORDING TO THE 2003 OWNERS MANUAL1. With Key on, (a short time after turning off the engine), press reset button located on drivers side instrument panel fuse block . Button is located at top.2. When the change oil light starts to flash, press and hold the reset button again3. The reset is complete when you hear the chimes and the CHANGE OIL light goes out
no you wait till you it changed
How do I reset the service engine light on a 2003 Chevy Trailblazer?
Check engine light is reset with a scan tool.Oil change due is reset by pressing "step" until "0 miles to service" is displayed. Then press and hold "reset" until it resets.