0
What else can I help you with?
Where is the oil pump located at on a 96 Chevy blazer?
You didn't say which engine you have but Chevrolet's oil pumps are located inside the oil pan.
What causes low oil pressure in rebuilt 350 Chevy?
Not sure, i would say oil pump or cam bearings
How do you change oil pump on 1989 LeBaron 2.5 non turbo?
As much as I hate to say it, if you need to replace your oil pump, there's a good chance your engine is in need of a rebuild.
How do you tell if the problem is oil pump or oil pump sensor on a 2002 misubishi lancer?
You didn't say what the problem is. But if you question the sensor, replace it, it probably cost lest than $20.
How do you replace the oil pump of a 96 mercury villager?
The oil pump assembly is behind the front timing cover and fits around the crankshaft snout. Needless to say, this requires considerable disassembly to get at.
What causes a 1989 Chevy Camaro not to have any oil pressure?
well i'd say it's a dead oil pump hands down
How do you replace oil pump feed pipe on Talbot samba?
Surely the trusty Haynes manual will say?
Why is your oil light staying on in your Lincoln ls and why is it making a knocking noise?
I would say your oil pump is not working. Assuming of course there is oil in your engine. Don't run it until you can have it checked by a mechanic because a blown engine is a lot worse than just replacing the oil pump.
If you change the oil pan is it a good idea to change the oil pump?
Oil pumps are pretty durable but Id say if you are having a low oil pressure issue then definately. But a good high volume (NOT HIGH PRESSURE!!) oil pump is a huge improvement over stock. PLUS they are cheap. Id say its worth the peace of mind seeins how you are right there and it only takes one bolt.
Where is the oil pump on a 2002 mercury villager?
Basically, it is behind the crankshaft pulley on the outside of the engine. To help visualize its' position, locate the oil filter mount. That is part of the oil pump. The timing belt, crank pulley, oil pan, and power steering pump must all be removed to gain access. Did you say you were thinking of replacing the timing belt anyway? Go for the water pump and belt tensioner too while you're at it.
What is the furthest distance from the pool that you can install the pool pump and filter?
I would say 10 yards easy. if the ground is flat.. if the pump is lower that the pool ? it may take a bigger pump ..use pvc. and never use tread tape on a plastic pump ! your pool pump repair guy in longwood fl.
Say does the 91 tempo gl have a fuse for the oil pump?
An oil pump is completely mechanically operated, and is internal to the engine. There is no fuse, because since it is not an electrical componet, there is no electricity involved in it's operation. If it has failed, the engine will have to be at least partially disassembled to service.
