With an ohm meter .05 ohms.You change the settings by loosening up the screws and the slowly turn the tps till the ohm meter reads ,05 while holding it in place tighten the screws and the cover the screws with finger nail polish this keeps them from backing out.Also makes it easier to adjust the next time just line up the polish marks. ...................thanks works great,,,,,,,,,,,,,,,,,,,,,,,,
NO ajust on tps sensor,. Replace
you dont, you replace it
tps will be located other side ofthrotle to accel cable check for clean connection at tps plug replace tps unless you can test unit dave.cop
TPS usually means throttle position sensor, and it doesn't have a "cable".
Check out something for the Throttle Position Sensor (TPS) in the askjeeves.com website. They have a lot of useful info.
Yes. Unhook and plug the hose going to the distributor, set the timing to factory specs, then replace the hose.
i would recommend eBay
How do you replace a starter in a 1997 F-350 Turbo Pickup?
Which belt? What year 350?
To remove the throttle position sensor: 1. Unplug the electrical harness. 2. Remove the bolt that holds the tps in place. 3. Remove the tps. To install a new tps reverse the removal procedure. There is no adjustment given.
You can't find it because they were NOT used in 1986
TPS is located on the TBI unit (front right)and cannot be replaced. you have to replace the entire TBI