You hold down the up and down buttons to the right of audio button
read the owner's manual
Borrowed from silverado answer: Push the set button and with the set light on, press either the scan or seek buttons to change...
Check the fuses Should have 2 fuses for radio/clock one for radio and a separate one for the memory circuits
If its like my '90, power off the radio so that the time displays. Then, hit Set. Then the Seek/Scan buttons will change the hours and minutes. When you are finished, hit Set again to get out of Clock Setting mode.
how do you set the clock on a 2003 chevrolet trailblazer
How to set clock on a 1992 oldsmobile achieva
The cost of insurance for a Chevy Silverado pickup is not a set price. The cost is determined by the driver, the company, and the coverage needed.
turn radio off n use radio knobs to set the clock
there should be two small squered buttons under the clock that have (H) for hour and (M) for minute
How do youchange the clock on a 2002 zx2 ford escort?
press the set button. the word set will light up hold the seek button until the correct hour. then press and hold the scan button until correct minute appears and your done good luck.
Idle is set by the computer.
Consult the owners manual.
There are two small black buttons. One at the bottom left hand corner of the tune button for hour and ond at the botton right hand corrner of the tune button for min. Note: They are hard to see. Hold the buttons in for app. 3 sec and the time will begin to increment.I have a 1993 Chevy Silverado and the clock is set like this: 1. Turn the ignition on.2. Turn radio off.3. Push set button.4. Push scan button for the hour and seek for minute.5. When time is set push set button again, then turn radio on.
Push the set button and with the set light on, press either the scan or seek buttons to change the hours and minutes. GoodluckJoe
Press and hold down clock button while pressing hr/min.
You must have an engine scanner to set the timing correctly.
The timing is set on a 98 Chevy Silverado 1500 5.7L by aligning the cam sprocket with the timing chain markings. The engine's computer will then make adjustments on the fly for any additional timing changes needed.
There is a little black button on the left of the tune/info knob power the stereo off Amd hold button for a few seconds and it should start changing the time.
If it is the factory radio turn on the ingition and make sure the radio is turned off, push the set button. for the hour push the seek button, for the minute push the scan button, to end push the set button again.
show me the radio in a 2002 Chevy mabliu l s or show me how to set the clock on the radio
Hit clock symbol button then adjust using the right tuning knob. Thanks, Wes
Press the set button then within 10 seconds use the seek and scan buttons to set the time.
hold set button then hit scan for mins. and seek for hour. then hit set