Chevy Metro
Chevy Silverado
Geo Metro

How do you set the timing on a 1999 Chevy Metro LSi?

454647

Top Answer
User Avatar
Wiki User
2006-04-02 03:59:27
2006-04-02 03:59:27

timing does not need to be set on the 1.3l engine in model year 1999 as it is a distributor less igniton system all timing is done by the ecm

1
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions

User Avatar

will a 1998 suzuki esteem 1.3 moter fit a 199 geo metro lsi

User Avatar

The fuel filter on a 2001 Chevy Metro LSI is located along the vehicle's frame, just beyond the fuel tank. It is positioned inline to prevent contaminants from reaching the engine and allow for easy replacement.

User Avatar

You won't find one. It didn't come with a cabin filter.

User Avatar

pcv valve is in the valve cover across from yhe intake plelum

User Avatar

I am tring to remove and install a water pump on a Chevy metro 2001 lsi.I would like some advice on how to remove and install a water pump.Thanks.

User Avatar

Owners manual. Regarding my question, the car came without an owners manual I do not have an owners manual either.

User Avatar

The '97 Geo Metro (Base, LSi or XFi) does not have a fuel light.

User Avatar

It is that black can looking thing on the left front of the engine comparrment. It has vacuum and eletrical lines.

User Avatar

I have a 1999 Chevy metro and I am in the process of replacing the fuel filter right now. You have to drop the gas tank and pull out the fuel pump (large circular part) and you will find the filter at the bottom of the pump. be sure you get the correct filter cuz I was sold the incorrect one. It shoud have a virtually flat elbow connection tube, not elevated like the one I bought.

User Avatar

5w30 i only use synthetic walmart supertech is great and cheaper than mobile

User Avatar

That's partially burned oil. From oil in your cylinders. Most likely from bad rings or bad valves.

User Avatar

mostly, yes. however Chevy bought GEO in 97 so there may be a few mods to the '98 it really depends on which parts you are referring

User Avatar

The only way to fix the dimmer switch is to replace it I have tried cleaning it lubercating it. nothing will fix it for good .so i had to replace it. It is a factory item.

User Avatar

You shouldn't be able to overheat a Geo Metro unless there is something wrong.

User Avatar

Might be the child lock is on. check that. I have a 98 Metro Lsi 4 door. and my door did the same ...but the child locks were bad and I had to have sum1 cut out those child locks. otherwise theyd never open ..good luck.

User Avatar

Its under the dash, driver side, on the left. There should be a white plastic cover over it showing the fuse diagram on it. It's shaped like kind of like an L

User Avatar

30w and if you want i higher quality oil, use synthetic

User Avatar

The fuse box is located under the dash just to the left of the steering column. It has a white cover on it, which makes it appear to be a relay instead of a fuse box.

User Avatar

There is a way to install anything on any car, but in this case, it's really not worth it. The time, money, and stress involved can easily justify buying a new car.

User Avatar

Look for the diagram sticker on the underside of the hood!

User Avatar

Disconnect any vacuum hoses from the distributor and plug them. Then you loosen the distributor hold down screws and turn it clockwise to advance the timing or counter clockwise to retard it. Tighten the hold downs, reconnect the vacuum lines and away you go.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.