answersLogoWhite

0


Top Answer
User Avatar
Wiki User
Answered 2006-12-24 01:28:16

Making sure you're not adding more then you car needs. When oil is leaking, either one you adding too much or 2) You need to replace your head casket seals.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0
User Avatar

Your Answer

Loading...

Still have questions?

Related Questions

What is correct torque for 1991 dodge Dakota valve cover?

If you are asking because of your valve cover leaking oil, there was a recall on that year valve cover gasket.


How do you fix an oil leak on a 1991 Grand Prix that is leaking directly above the starter?

Valve cover gaskets?


Where is the PCV valve located on a 1991 Pontiac Sunbird V6?

on the valve cover


What is wrong with the engine of the 1991 Acura Legend when after it has been running for a while a burning oil smell occurs?

Gasket is leaking oil. Valve cover gasket is likely suspect.


Pcv valve on a 1991 Jeep Cherokee Laredo?

it doesn't have an official pcv valve just the vent fittings which need to be cleaned out periodically.they are the elbows on the valve cover,clean the tubes out also.spray a little carb cleaner inside let sit and hose out


Where is the PCV valve on a 1991 Chevy Van motor 5.7?

Pass side valve cover.


Where is the PCV valve located on a 1991 Buick Regal Custom 3800?

the PCV valve is located on the valve cover of a 1991 Regal Custom. It is plugged in and can be easily changed.


How to tell if you have a Valve Cover Leak on 1991 Camaro?

you will see oil all around the valve cover and running down the side of the block.


Where is the PCV valve located on a 1991 Buick Skylark?

The PVC valve for a 1991 Skylark should be located on the top of the valve cover. It is a plug in type, twist and pull to remove.


Where is the PVC valve located on 1991 Buick century?

The PCV valve plugs into the rocker arms cover or intake manifold.


Where is the PVC valve on a 1991 Buick century 3300 motor?

typically ther're on the top of the valve cover or on the intake manifold.


Where is the PCV valve on a 4 cylinder 1991 Jeep Wrangler?

its on the valve cover right behind the oil fill cap..


What year Jeep Cherokee computer fits a 1991 Jeep Cherokee?

A 1991 Jeep Cherokee computer is what fits a 1991 Jeep Cherokee.


Where is the coil located on a 1991 Chevy S10 4.3?

On the right side valve cover.


Where is location PCV valve on 1991 ford f 150?

in the rocker arm cover


How do you change PC valve on 1991 beretta gt 3.1 engine?

There is a big hose in the front valve cover it is at the end of that hose...


Where is the PCV valve in a 1991 2.5 Jeep wrangler?

Its on the front of the valve cover the first hole behind the oil fill hole


Where do I locate the PVC valve on my 1991 3.1 Chevy Corsica?

It is very easy to access in the left hand valve cover near the oil fill opening. This is the valve cover closer to the radiator. If you pull it up, it will slide out.


1991 jeep Cherokee Inline 6 with thermostat on front was overheating so I checked and replaced valve cover seal still overheats after running for more than 10 min?

changing the valve cover gasket will not fix an over heating problem u need to check out the cooling system. Radiator, water pump, hoses, belts


Where is the PCV valve located on a 1991 Ford F150?

I have a 5.8L in my 1990 and it is located behind the intake on the passenger side. Right by the valve cover.


Where is the pcv valve located on a 1991 Oldsmobile cutlass supreme?

its in back valve cover at fire wall i removed the plenum from the intake manifold to get at it.


Where is the PCV Valve located in a 1991 Chevrolet Caprice?

For the 305 (LO3), the PCV valve is located on the driver's side valve cover. It's held in place with a rubber grommet.


Where is transmission dipstick located 1991 Caprice?

The transmission dipstick for the 1991 Chevrolet Caprice is located on the side of the transmission. It will be behind a valve cover.


Where is the PCV Valve on a 1991 Cadillac Seville located?

it is on the inboard side of the front valve cover driverside end, you will need to replace the grommet also


Where is the PCV valve located in a 1991 Toyota 4Runner v6?

Its on the passanger side valve cover under a clutter of little hoses near the firewall