turn the bolt counterclock wise to get it off. I am surprised you did not ask how do you keep engine from turning as you attempt to undo the crank bolt.
it is mounted to the drivers side rear of cylinder head. Should be a bolt that holds it in place. Easier if you take thee hood off.
Take out the screws.
205-75-15
no you do not need to, but if you are rebuilding the engine i would.
For a 2002 Kia Sportage the recommended oil to be used is a 10W-30. Most vehicles use this weight of oil. Depending on the climate it is best to stick with the recommended oil weight for your vehicle.
It could be that your clutch is not longer working. You should take your car to a car mechanic, so that you can get it fixed.
You will see a key in the crank. Turn the crank until #1 piston is all the way up in the cylinder. You will see that the key in the crank will be stright up. and when you put the crank gear ( SMALL GEAR ) on, The dot on it will be stright up. Now the cam gear ( BIG GEAR ) bolt it on the cam, and find the dot on it. leave chain off for now. Then take and turn the cam gear until the dot is stright down over top of the crank gear dot. It will be hard to turn, but turn it with something. Now remove the cam gear and put chain and gear back on. Tighten all 3 bolts TIGHT on the cam gear. Now check the 2 dots, They should be stright over top of each other in a stright line. THATS IT. Put it all back together now.
Located behind the starter. Have to take starter off to get to it.
there is a plug on the side of the tranny that u take out. the level should be even with this plug
counter clockwise. That is once you'ved braced the engine so it won't turn when you try to undo it.
crank shaft sensor take off and clean it is on the bell housing ofthe gear box
cam shaft have noyth that must be at 12:00, crankshaft you will have to take harmonic balancer off and look about 1:oo to see it.