0
How do you take off the harmonic balancer on a 1988 Ford Ranger?
Wiki User
∙ 17y ago
Pull the belts, remove the center retaining bolt then use a harmonic balancer puller to remove the pulley. Make sure you use a disk that will protect the threads of the cranshaft when you tighten the puller.
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
Where is the crankshaft position sensor located on a 1997 ford ranger xlt?
That should be at the front of the engine by the crankshaft pulley / harmonic balancer
Wear are the the timing marks on a 1988 2.3 liter ford mustane lx?
on the harmonic balancer behind the crank pulley
Where are the timing marks on 1994 ford ranger?
under the hood , on the harmonic balancer and the timin marks on the timin eye marker with a timin light
How do remove the harmonic balancer on a 1996 ford ranger xlt 2.3?
After removing the bolt, use a large gear puller. Tighten the puller, tap the head with a hammer, then tighten again. After a few repetitions the balancer will break free.
Where are the timing marks on 1980 ford courier?
on the harmonic balancer, at crank shaft
Where is the crankshaft sensor located on a 1997 ford ranger 2.3 L?
The crank shaft sensor is located jusy behind the harmonic balancer just to tge left as you are facing the engine.
What would cause an engine vibration when in drive at a stop light on a 1996 Ford Contour 2-liter Zetec with automatic transmission?
check harmonic balancer. check harmonic balancer.
How do you remove harmonic balancer off 2001 Ford Focus?
You need a pulley puller.
What is the torque setting for the harmonic balancer for an AU series 2 ford?
6cyl is 125nm
What way does the harmonic balancer bolt turn on a 61 ford 170ci 6cyl to remove?
Counterclockwise
What are torque specifications for 1982 Ford 302 harmonic balancer?
75 lbs 75 lbs
How do you install harmonic balancer in 1978 ford truck?
First remove the old one using a puller that you screw into the harmonic balancer there is a key on it so you can not put the new one on wrong just use the bolt that holds the main pully on to push the balancer on
