0
Disconnect the battery, Disconnect all the stuff bolted onto the transmission and transfer case, disconnect the drive shafts, use a transmission jack to remove the transfer case, then use the tranny jack to remove the transmission. Remove the clutch basket or torque converter from the flywheel. Reassemble in reverse order. Take a few pictures first, label any wires or linkages so they get put back in the right place. Its much easier to pay a mechanic though
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
How much transmission oil does 1986 ford bronco takes?
about 13 quarts.
Will a 1993 ford ranger manual transmission fit in a 1986 ford bronco?
no.
How much transmission fluid does a 1986 Ford Bronco II take What if it is totally dry?
10.5 Quarts if the torque converter is dry also.
How do you take a intake off a 1986 2.9 bronco 2?
You will need to take a screwdriver or knife to take the intake off of a 1986 2.9 Bronco 2. Just take and pry the intake off. It is very easy to do.
What transmission will fit a 1986 ford bronco 2 with the 2.9 motor?
I believe that is one of the versions of an ( A4LD ) 4 speed automatic transmission
Why did you loose over drive on your 1986 ford bronco?
when my transmission was no longer good about 225,ooo klm
Does the 1986 Ford Bronco 2 take R134 AC refrigerant?
A 1986 Ford Bronco II would use R12 unless it has been converted
Can you take 1990 bronco and swap that automatic transmission for a manual transmission?
Sure, but you will have to change many, many, many other parts along with the transmission. I would suggest purchasing a 1990 Bronco like yours that has a standard transmission to use as a parts car.
Where is Inertia fuel switch location 1986 bronco ii?
under the dash near the transmission tunnel on the passenger side floor
Will a aod transmission go into a 91 bronco?
An AOD transmission can go into a 91 Bronco with a little fabrication.
What's the weight of a 1986 ford bronco?
The Ford Bronco is categorized in one of five generations, with the 1986 model falling within the 3rd generation. The base curb weight of a 1986 Ford Bronco is approximately 4374 lbs.
Will the auto trans from 1986 302 bronco work in a 1989 351 bronco?
it shold
