Use a crowbar trust me use a hack saw or some thing like a welder if this doesent work go to a metal marketer
remove the door pins
You have remove the door trim. You will need 10mm socket be careful when you loosen the nuts they can fall inside the the door shell.
You take it to an auto shop and have them do it
you need to remove the screw directly behind the door handle, then rotate the cover off the handle then pry the clips around the outside of the door and pull up. to put it back on you just reverse what you did to take it off
On the oil cap it says "5 W 30".
Hey guys, I trying to take off a fan clutch on my 2003 chev blazer and want to know if I have to remove the radiator to do it.
take it to a auto shop
I've got a 91 s10 truck and I'm trying to get the panes replaced...I've tried to take them off according to the manual but, the plastic pins holding them to the metal are so old that they are breaking.
You have to take the door apart
You probably should have a professional do that, it is not an easy job, they are under the upper intake plenum.
www.coloradok5.com is the available option. they provide the parts in a better quality and affordable price as well. That's a tough vehicle take good care of it. I found a link with what you are looking for, visit, www.thefind.com/cars/info-chevrolet-k5-blazer www.thefind.com/cars/info-chevrolet-k5-blazer .
A Chevrolet Blazer with a 4.3 liter vortec engine will take approximately 6 quarts of oil. The recommended type of oil is 5 W 30.
700R4 getting ready to take mine out for the 4th time. Hopefully it will be the last.
on mine i had to take the door panel off to get to the bolts, after that its easy
out a s10 short bed truck putting back does the front have to have the bushing by the seal can you take it off
Take the door panel off and there are bolts inside.
Take the positive cable off the battery, then you have to remove the inspection shield on the transmission and then take the two bolts out of the starter
in my 99 you have to take the whole door panel off. Just unscrew the door handle on the inside and the little round tab where the door meets the car.
take the screws out of the door hanle to separate the inside door molding from the body then just pull he door molding off from multiple locations in a pattern around it.
2002 blazer want take gas
Take all your body mounts out and lift your body a couple of inches and block it and you will be able to get to them with ease.
You have to take off the door panel and take the 2 bolts out holding the mirror in place
pull out the outer edges of the door panel. then take out the screw behind the door handle. there are 2 screws under the armrest you need to take out. after all that is done pll door panel towards you and lift up. then take out the four screws around the speaker and put it all back together doin all this in reverse.
When removing the door panel, you need to remove all of the screws first. Then pull the door panel off. There should be screws around the edges or the door panel, and 1-2 screw on the door handle(on the inside). Then pop the door panel off, if the blazer has electric windows and locks you have to disconect them first, if it doesnt have power locks and windows, you have to take the window crank off,there should be a screw in the center of that. Unscrew the door lock and pull up. If it doesnt have them locks then you have to disconect it from inside the door panel
what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer what all i need to take a water pump on a 99 Chevy blazer