answersLogoWhite

0


Best Answer

Well, if your Jeep was a soft top to begin with, the switches and wiring probably aren't there, but you should find an unused connector in the back under the rail that the top is bolted to.

Tracing those up front to where they would connect into the dash may be more difficult, and of course the switches won't be in the dash.

If it were me, I would run 2 fused power wires from 2 unused slots in the fuse panel to 2 new switches you buy from the auto parts store, then from the switches run 2 wires back to the connector ( or locate the ones that already run back there ) and you will be good to go.

User Avatar

Wiki User

13y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How do you tell if your jeep wrangler has hook ups for a hard top with defrost and windshield wiper to he hard top has a wiring harness where do I plug this into I have a 2002 Wrangler?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Will 92-95 wrangler gauges fit in a 87-91 wrangler?

NO... mechanical speedo vs. electrical. fuel sending unit differs and different harness for under dash


Would a radio and wiring harness from a jeep Cherokee interchange with a 1998 Jeep Wrangler?

30x 10.5


How do you replace the flasher relay on a 2000 jeep wrangler?

Follow the wiring harness from your blinker. Disconnect the factory harness from the relay. Replace with the new relay.


Can you put a engine from a 2006 Cherokee into a 1989 wrangler islander?

Yes, but you will also need the wiring harness and ecm.


Will a 1995 4.0 Cherokee engine drop right in to your 1990 wrangler?

No. 1995 cherokee engine is fuel injected with different gas tank, fuel pump, engine computer, water pump and wiring harness. 1990 wrangler has a carb.


Is a new connector plug for the alternator on my 1999 jeep wrangler available without having to buy the complete wiring harness?

What you need is an alternator wiring pigtail harness from the dealer!


1997 jeep wrangler 2.5 to 4.0 engine swap?

You will need a different trans, engine, radiator, wiring harness, computer, etc..


Is a 1993 Jeep Wrangler 4.0 6cyl engine interchangable with a 1989 Jeep Wrangler 6cyl frame with out cutting and welding and changing wiring harness?

Yes, that should work just fine, they are both YJ's and 6 cylinders so all should match.


Where is the cam sensor on a 1998 wrangler?

The cam position sensor is inside the distributor. There is a wire harness that exits the side of the distributor. That's it. You have to remove the distributor to change that sensor.


Where is the rear washer reservoir on a 2000 Jeep Wrangler - Sahara?

When you first buy the wiring harness for your hardtop, you would have been sent a larger reservoir to replace the stock one that is used only for the front windshield, so there is one reservoir for both, only if you have a hardtop, your reservoir should be bigger hope this helps


What does it take to swap a 2.5 motor from a 1992 Jeep Wrangler YJ to a newer 2.5 motor from a 1998 Jeep Wrangler TJ?

complete engine, wiring harness, and computers. you may also need the tranny if they are different because the computer needs to connect to the tranny as well and won't work properly if they're different.


Will a 2004 Jeep Wrangler stock radio fit 1999?

It will If you willing to do the work the radio harness is different and the radio trim bezel changed in 2003 so you would have to make it work.