Disconnect battery.
You can't disable the airbag on the driver side. You could remove the airbag.
simply pull tha airbag fuse. remove the 4 torx head scres behind the airbag and remove airbag. unplug theelectrical connector. remove the big nut holding the steering whell. use a puller to remove the steering wheel.
To remove the steering wheel start by disconnecting the negative battery terminal to prevent accidental airbag deployment. Then remove the screws on the backside of the steering wheel to remove the airbag. Disconnect the airbag wiring connectors. Remove the steering column shaft nut and remove the steering wheel with a puller. Do not yank, hammer, pry the steering wheel off as this could result in steering shaft damage.
4 bolts are romoved from the backsode of the steering wheel. If airbag equipped remove airbag fuse first. Then remove airbag/ horn/ center assembly. Remove large nut from center of wheel, then pull wheel with steering wheel puller.
# Disable airbag system. # Remove steering column covers and lower instrument panel cover # Lower steering column # Disconnect the shift interlock cable from ignition lock housing # The lock assembly is clamped to the steering column by two shear-head bolts. Drill heads off each bolt and remove the bracket. # Remove the steering lock assembly from the steering column
Airbag disableTurn the sterring wheel to the straight ahead position, place the ignition switch in lock, remove the key, then remove the airbag fuse from the fuse block. Remove the knee bolster and sound insulator panel below the instrument panel. Unplug the yellow connector position assurance (CPA) sterring column harness connector at the base of the steering column.
Do not do this during an electrical storm. Disconnect negative battery cable. Wait 10 minutes. Remove the bolts holding the airbag bodule/horn pad to the steering wheel (from the back.) Hold the airbag module with one hand, then with the other hand unplug the horn wire and airbag wire. Move the airbag module away from the car. Set it down someplace out of the way and face up where other people won't go near it. Remove the nut and circlip at the center of the steering wheel. Use a steering wheel puller or two-bolt puller to pull the stering wheel off the column.
Don't do that!It's a major mistake to do that!The airbag is a safety device. It is illegal to disable an air bag without written permission from the NHTSA
you would need to disconnect the airbag then pop off the horn pad and remove the airbag then unbolt the steering wheel.
ok you have to check on your steering wheel in back of you steering wheel there will be a 2 or 4 bolts you gonna have to remove ,as soon your remove you steering wheel airbag you should see 2 wires one goes to airbag on other will be connected to you steering wheel switches ,,you should remove that and after that you gonna see one bolt you should remove it and you can after that you should be able to pull you steering wheel
You can't. But you can disable it. In the door there should be a place where you can put your keys into. Turn it. Well Done. Airbag Disabled
To remove the driver's steering wheel airbag on a 1999 Holden Commodore you will need a special set of tools to remove the 4 to 6 security screws that are holding it in. If the vehicle came equipped with a airbag, it needs to have one to remain road safe.