0
for computer testing, just take it into your local shucks orilly store, and ask them to run a computer diagnostics on it
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
Where is the flasher unit in a 1998 Ford Contour?
The flasher unit is on the left hand side in the steering column.remove 3 screws on top and 3 on the bottom,with a Phillips screwdriver,push up clip and pull out.
Where is fuil sending unit for Ford Contour?
it is under the back seat you need to take off the back seat
What would make a 2000 ford contour sputters like its running out of gas but it has a full tank of gas like its running out of gas but it has a full tank af gas and a new fuel filter?
Could be the servo unit in the transmission. Had the same problem and replaced the fuel pump in our 1999 ford contour but it was the servo unit.
Where is the temperature sender on a 1998 Ford Fiesta 1.3?
The 1998 Ford Fiesta 1.3 liter engine temperature sending unit can be found on the front of the engine. The temperature sending unit will be near the thermostat housing.
Where is the oil pressure sending unit on a 1995 Ford contour?
under the rubber of the front left tire under the rubber of the front left tire
Where is the fuel pump on 1998 ford van?
in the fuel tank it is attached to the sending unit
Where is the oil pressure sending unit on a 1999 Ford contour 2.5 L 155 Cid V6 DOHC?
it sits behind ac compressor on the 2.5l
How do you test temperature sending unit on 89 ford ranger?
The temperature sending unit can be checked cold, and then hot, for resistance change. The test is performed with an ohm meter.
How do you replace a temperature sending unit on a 1998 Ford Contour?
Follow the main hose that goes from radiator to engine block. It is on engine block between the main hose connected to engine block and a pullye. The heat gauge wire is snapped on the sensor. Remove the wire and replace the sensor.
On a 95 Ford Contour is the ac freon R12 or R134.?
As this was the year of the switch, it can have either. There should be a sticker somewhere on the unit listing what it has. Any A/C professional can tell you.
Why is fluid coming out of dipstick tube on your Ford Contour?
It is possible that the transmission is overfull and the pressure in the unit is forcing out the excess. Also, it is possible that the transmission is overheating and boiling the the fluid.
Where is the oil pressure sending unit on a 1998 ford contour svt?
It is on the engine block to the passenger side of the oil filter. You cannot see it from any angle unless you do major dismantling of parts in that area. You have to remove the oil filter to even reach it. It is VERY VERY hard to remove without removing parts but it can be done. Feel for the wire that plugs onto the sender unit.
