ecm connect with vehicles engine not a electric system
re-programming the ECM (Engine Control Module)
ECM stands for engine control module / COMPUTER
I believe that has the DIS, distributerless ignition system, if so there is no timing adjustment. The timing is controlled by the ignition module, crankshaft sensor and the ECM (engine computer). Try having some run a test using and OSB tester. Sometimes if the sensor is going bad it will show.
The engine speed sensor provides the ECM with a crankshaft position signal. The ECM uses the signal to determine a crankshaft reference point (Top Dead Center) and calculate engine speed (RPM.) The signal is also used by the On-Board Diagnostic system for misfire detection. The ignition system will not operate if the ECM does not receive an engine speed sensor input.
Yes the ecm and the engine computer are the same thing.
Testing an ECM requires it to be installed on the vehicle.
Engine,Emission Control System,EGR (Exhaust Gas Recirculation Valve),Exhaust system,ECM (Engine Control Module),
Engine,Emission Control System,EGR (Exhaust Gas Recirculation Valve),Exhaust system,ECM (Engine Control Module),
This system does not have a "Fuel mix valve" it should have one single injector that sets above a venturi (throttle body) that is controlled by the ECM (computer).
Engine control module. It controls the engine-related electronics.
The ecm (engine control module) does just that, controls the engine.