if a serpentine belt is loose, it needs replacing. there is an automatic tension pulley on all serpentine belts. so just buy a new belt and install
If you've got a 4.0 litre engine than you've got a Automatic belt tensioner on the engine. Sits to the right of the alternator. If your belt is loose, than you need to check that the belt is on properly on all the pulleys, or if you have the right belt. If the belt was made for a motor with A/C and yours doesn't have that, then the belt will be to long. Check with your local auto part supply store. Hope this helps...... For info on how to route the belt, get a chiltons manuel and it will have a diagram.
There is no idle pulley on 1995 GC's with 4.0 Inline 6. To replece the serpentine belt; 1) Draw a diagram of the existing routing. 2) Loosen the alternator. 3)Remove old belt and compare to the new belt. 4) Install new belt. 5) Tighten new belt by tightening alternator. on the 5.2 and 5.6 just rotate tension pulley to the right if you are standing in front of Jeep install and release the tension pulley and let it tighten
There should be a diagram on the underside of the hood.
Possible problem with the alternator. Could be source of the noise if it's bearing is going out.
go to the parts store and ask for a belt for that vehicle
How do you tighten the serpentine belt on an oldsmobile ciera
You don't tighten a serpentine belt. The tension is controlled by a tensioner. If it is loose, then the belt has stretched and needs replacing.
Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.
Most serpentine belt systems have a self adjusting tensioner.
You do not tighten a serpentine belt. It has a tensioner that keeps it at the correct tension. If it is loose, either the belt is worn and needs replacing or the tensioner is defective.
You can tighten the serpentine belt on your 2005 Chrysler 300 by tightening the tensioner pulley. Push the tensioner pulley to the right until the serpentine belt is tight.
the Serpentine Belt on the 91 Lebaron is on Tension Pulley, you dont tighten it. But if it is loose and you need to tighten it you just go and buy a new belt and put that on.
Serpentine belt? You may have to remove to tighten alternator
usually serpentine belts get their tension(tightness) from the belt tensioner
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.
Loosen the tensioner pulley. The serpentine belt will become loose and can be removed. Put the new serpentine belt on and tighten the tensioner pulley.
Where can i find a serpentine belt diagram for a 1993 s-10 chevrolet blaze?