you don't tighten a serpentine belt the tension is supplied by a tension pulley if belt is loose, it is time to replace belt or tension pully if tension pully needs repplacing belt will be worn anyway
It should have an automatic tensioner, and no adjustment is provided.
If your vehicle has an automatic belt tensioner with a serpentine belt, the belt is worn and needs to be replaced. On older models, the belt tension can be set by adjusting it at the alternator bracket. Loosen but do not remove the two bolts that hold the alternator in place (one at the bracket and one on the block) and pull the alternator to tighten the belt. Hold in position while re-tightening the bracket bolt then tighten the bolt on the block.
The Jeep Grand Cherokee did not exist until 1993.
If you've got a 4.0 litre engine than you've got a Automatic belt tensioner on the engine. Sits to the right of the alternator. If your belt is loose, than you need to check that the belt is on properly on all the pulleys, or if you have the right belt. If the belt was made for a motor with A/C and yours doesn't have that, then the belt will be to long. Check with your local auto part supply store. Hope this helps...... For info on how to route the belt, get a chiltons manuel and it will have a diagram.
Should be done automatically by the belt tensioner - if not tensioner could be bad
How do you tighten the serpentine belt on an oldsmobile ciera
You don't tighten a serpentine belt. The tension is controlled by a tensioner. If it is loose, then the belt has stretched and needs replacing.
Most serpentine belt systems have a self adjusting tensioner.
Put the serpentine belt around the pulleys on your 2001 Chrysler LHS. Tighten the serpentine belt by pushing the tensioner pulley to the left. Tighten down the tensioner pulley and the serpentine belt will be tight.
You do not tighten a serpentine belt. It has a tensioner that keeps it at the correct tension. If it is loose, either the belt is worn and needs replacing or the tensioner is defective.
You can tighten the serpentine belt on your 2005 Chrysler 300 by tightening the tensioner pulley. Push the tensioner pulley to the right until the serpentine belt is tight.
Serpentine belt? You may have to remove to tighten alternator
the Serpentine Belt on the 91 Lebaron is on Tension Pulley, you dont tighten it. But if it is loose and you need to tighten it you just go and buy a new belt and put that on.
usually serpentine belts get their tension(tightness) from the belt tensioner
Where can i find a serpentine belt diagram for a 1993 s-10 chevrolet blaze?
Put the serpentine belt on to the pulleys of your 1994 Chevy engine. Tighten a serpentine belt with the tensioner pulley.