answersLogoWhite
Auto Parts and Repairs
Buick Regal
Toyota 4Runner
Toyota RAV4

How do you turn off the low tire light on a 2004 4Runner?

293031

Top Answer
User Avatar
Wiki User
2015-07-15 18:55:54
2015-07-15 18:55:54

Fill the tires with the correct air pressure.

___________

Don't forget to check the spare too.

1

Related Questions

User Avatar

The light for the glove compartment on a 2001 4Runner is in the unit itself. When the glove box is opened the light will turn on.

User Avatar

I have a 2004 Impala SS. I currently have a aftermarket deck, the only other way to turn off the low tire pressure light is either 1) bringing it into the dealer, or 2) turn your key to the accessories position, turn your lights on and off three to five times, and it should have shut off your low tire pressure light.

User Avatar

turn on key and depress the reset button. let tire light flash 3 times and turn it off. this resets the 98/99 sienna. it may also work on the forerunner

User Avatar

Turn the 4Runner on, make sure that you are looking at the "odometer" miles and not the "Trip" miles. Turn the 4Runner off, hold the "reset" button, turn the 4Runner On and the "MAINT" light will blink 3 times. Release the "reset" button and the light will turn off. This worked great for me but the light flashed 5 times then went off. 2007 SR5 4WD 16,000 miles recently purchased from dealer hopefully there is nothing else wrong/ FYI the manual told me that the maint light is for oil change.

User Avatar

Reset the light by following the procedure below: 1. Turn the ignition key to the "OFF" position. 2. Turn the ignition key to the "ON" position while holding down the trip meter reset button.

User Avatar

The light will remain on if one of the tires has low air or if one of the tire sensors is bad. Make sure all of the tires have the proper amount of air, if they do then take it to a tire shop and to replace the bad sensor.

User Avatar

A Lexus ES 350 tire pressure light will reset on its own. Tire pressure lights will turn off when the tire is at the proper pressure.

User Avatar

The light should turn off after the tire(s) is inflated

User Avatar

either the wiring needs to be redone, or the light bulb burnt out.

User Avatar

How do you turn off running lights on 2000 Toyota 4runner?"

User Avatar

First of all check the spare tire pressure.

User Avatar

AnswerStart by making sure the odometer is on actual mileage. Turn the key "off" press and hold the "reset" button on the upper left of the instrument panel. Turn the key "on" (engine off); the maintenance light will flash then turn off. Release the "reset" button and it's done!

User Avatar

Have you checked the spare tire yet? I hear that if the spare is too low the light will stay on.

User Avatar

It should turn off automatically after you put in the correct tire pressure. I just did this the other day.

User Avatar

Place car key in on position and use your left hand to press down on button located on bottom left hand side of steering wheel. the tire pressure light will flash four times checking all for tires. make sure that your have check and serviced your tire pressure before turning the light off.

User Avatar

how do you reset the tire pressure monitoring system on a 2006 Toyota Rav4?

User Avatar

Inflate the tire to the correct pressure and then drive the vehicle

User Avatar

make sure you have the proper tire pressure, 32 psi. It will turn on even if it is over inflated.

User Avatar

the horseshoe shaped light is your low tire pressure warning light. check your tire pressure in all of your tires. the light will turn off once the tires are at the proper PSI.

User Avatar

You can turn off the low tire light, on your 2005 Toyota tundra, by holding in the reset button. You can also remove the fuse for 10 seconds and replace it to its original slot.

User Avatar

its the same, you have to follow the instructions to the letter! ________________________________________________ Make sure trip meter is on total mileage window. Turn key to off ign While pushing down and holding on the reset/trip button, turn the ign to on position MAINT light will flash a couple of times and turn solid again, turn key to off position Turn the ign to on position and the MAINT light should be off now.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.