Want this question answered?
If you have a valet switch, just hold it in for a few seconds with the alarm off and release when it beeps or blinks the LED. You may be able to unhook the battery briefly to reset the alarm's status.
A visual notification that the alarm is in valet mode is the LED light is on solid. If the LED is on solid and you wish to make the alarm active again, turn the ignition "on" then, press and hold the valet/programming switch for two seconds. The LED light will turn off.If the LED light is not on solid then, the issue may be with siren itself.
<p>try turning your key on and flip the valet switch, your alarm is most likely in valet mode (youll know cause the led stays on) if that doesnt work, turn the key on and off then toggle thye valet switch 3x and that'll turn off silent mode. contact@adrianbarascu.ro<p>
put key in ignition, turn to on position, reach down to flashing light button and hold down until light is a steady red.
my ignition on my Honda accord will not turn over all of a sudden.could this have something to do with the viper alarm? thanks
Put key in the ignition turn key to on/run position, then back 1 click to acessories position repeat 2 more times (3 total)
Just dont get ya car valeted ha
Your alarm system is in valet mode. To fix this problem: Unlock the car, and open the door. With the door open, and the car unlocked, press: LOCK/UNLOCK button ONCE, press the AUX button ONCE, and then press the LOCK/UNLOCK button ONCE more. When you press this key combination, the vehicle security system should begin functioning correctly again.
to set a alarm you just press the ''MODE'' buttion
What do you mean by "valet mode"? If you mean the trunk release button won't work, there's a valet switch inside the glove compartment that activates and deactivates it. Just turn it off. OR You use the black key in the trunk keyhole which is located in the xk8 emblem. The Keyhole is located between the x and k. That should take it of valet mode.
Turn off the alarm by pressing the upper and lower buttons on the right side of the watch while it is in time mode.
I'm looking for the location of the valet switch on a 2003 ford expedition. my factory alarm system seem to be stuck in the on mode which has cause the SUV to not turn over at all. I first thought that it was a starter promblem so i replaced it. same deal, no difference. if anyone have a clue as to what may be going on please respond as soon as possible. thanks