there is switch located next to the dimmer switch and that is the key to your problems
If it is equipped with fog lights, you turn them on by pulling the headlight switch out one notch after turning the headlights on.
If you have factory installed fog lights (driving lights) you have to pull out the knob on the light stem towards the direction of the drivers side mirror
I believe you turn on your low beam headlights and then pull out on the selector switch to turn on the fog lights and then push it in to shut the fog lights off
Fog lights are only accessable when headlights are on; once headlights are on, pull shaft/stalk out to turn on fog lights.
Usually by pulling the light switch out 1 click.
turn on your fog lights
Turn your low beam headlamps on and then pull out towards you on the headlamp control to turn the fog lights on / push in to turn fog lights off
go slower. leave your lights on. turn on your fog lights(if you have them) and do not turn on your bright lights!(in heavy fog) it will make it difficult to see for you and other drivers.
Pull straight out, not up towards you, that changes the lights from low beam to high and back, on the handle where you cut your lights on and off. The end cap is actually the switch for the fog lights.
With your low beam headlights on , pull the headlight control towards you
The rotary dial for the lights pulls out to turn on the fog lamps.
It is the same as the switch to turn on the headlights. Pull it out toward you.