Want this question answered?
iveco truck just wont start . just parked up and unlaoded got back in on ignition lights and wont start
There is a 14 mm bolt on back of caliper. Remove this & use a 4 mm Allen wrench to back piston into caliper.
Remove tires unbolt caliper remove old pads compress piston back into caliper put new pads on put caliper back on put wheels back on
Carefully take the boot out of the caliper with a small screwdriver being careful of the seal underneath. Then put the cylinder back in the boot and replace the whole thing back in the caliper.
Why do caliper bolts back out on a Chevy K5 Blazer 4*4?
Make sure caliper pistons are pressed in
You will need special brake caliper tool such as a C-clamp to push back the piston on the caliper of a 2002 Mitsubishi Lancer.
There is a specialty tool for this procedure. There is a metal plate that fits on the piston, then a clamp for the back of the caliper. Turning a screw will pull in the caliper. Opening the bleeder valve may be necessary.
HELLO IF YOU HAVE TAKEN OFF THE TWO BOLTS AND STILL WONT COME OFF USE A SCREW DRIVER AND PRY THE CALIPER UP FROM BETWEEN THE ROTOR AND CALIPER ALSO YOU CAN PUSH THE CALIPER BACK TOWARDS THE INNER SPRING BETWEEN THE CALIPER AND ROTOR SITS THIS WILL PUSH THE CALIPER BACK AND GIVE YOU EXTRA CLEARANCE TO PULL UP THE CALIPER
Knock pins out holding the caliper in place. Pull caliper off of rotor. Remove old pads from inside of caliper. Sometimes, the back pad will still be sitting against the back of the rotor. Replace front pad back in the same grooves on the caliper.
Front brakes or back> front is really simple, when you take the caliper off, the caliper is held on with 2 1/2 bolts... the rotor will come off if your going to replace that to, it will slide off the spindels when the caliper is removed... put the new pads in place and slide the caliper back on and put the 2 bolts back in to hold the caliper in place.
On the back of the caliper there should be a bolt its a 14mm you take it out and inside there is a bolt also its Allen key you use and Allen key and retract the caliper. it works on all 626 from 1994 till 2002