0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Radiator fan does not work?
Run a hot wire to the positive wire on the radiator fan. If it works, then you have a fuse or a relay (or even a short in the wire). If it doesn't work at all, then the fan motor is bad.
How does a hot wire relay work?
35 ampRefrigeratorRun a hot wire to the positive wire on the radiator fan
What would cause radiator fan to constantly click on and off?
on most vehicles the radiator fan is wired up to a relay so that the fan will remain off until the car is warmed up. they do this so your car will warm up to NOT (normal operating temperture) faster. if you are good with wiring you could wire the fan up to a switch so you can turn it on or off when needed.
The electric fan for the radiator does not kick in when the temp goes up at idle How do you find the coolant temp sensor for the fan of a Chevrolet Celebrity 1984?
First, un plug the wire at the fan, jump the wire and see if the fan does work. If it does, trace the wire back to the sensor, there are only 2 sensors, 1 for temp gauge, and 1 for the fan.
Where is the temperature sending unit for the cooling fan located on a 1995 Chrysler lebaron?
The computer uses the two wire sensor near where the upper radiator hose attaches to the engine to decide when to activate the radiator fan.The computer uses the two wire sensor near where the upper radiator hose attaches to the engine to decide when to activate the radiator fan.
Why does radiator fan fuse keep blowing on a 2002 Saturn?
The TYPICAL reason that the radiator fan fuse blows is because the radiator fan has failed. Usually either a failed motor winding (coil of wire inside) or a seized bearing. Either way, you probably need a new fan.
Your 86 kawasaki 454 ltd is still over heating after you changed the radiator thermostat and fan?
does the fan even turn on? my bike was over heating because i broke the fan switch on the bottom of the radiator. i ground the wire too the frame and the fan turned on and cooled the radiator down. note the fan will still run if u turn your bike off . so what i did was loosen the switch which also drains the radiator. and soldered a wire on the center pin and reinstalled it . replaced the antifreeze and now the bike runs great.
Your radiator fan does not come on on a 1995 Pontiac Bonneville?
The radiator fan sensor switch or the radiator fan motor are at fault (maybe even both). Wire the fan motor direct to see if it will run, if it does, replace the sensor switch. If the fan motor doesn't run, replace the fan motor before you buy a new sensor. If after replacing the fan motor, the fan still doesn't run, then replace the sensor.
How do you wire a rocker switch to radiator fan on a Grand Am?
to shut the fans on and off by yourself. remove the connector for the wires at the fan. hook a wire from the positive on fan motor to the inside toggle switch, do not hook to switch yet. run a wire from the positive on battery, hook to battery after hooking up switch. hook up the wires to the switch. then the battery. its up to you if you want to install a 15 amp fuse in line from battery to toggle switch.. you can also get the power from the fuse box instead of the battery. this should work for you. if not you may need to ground the other fan wire.
Where is location of fusible link in 1995 Volvo?
It is a grey wire that comes off the starter and turns into the Big Red single wire that goes into the cooling fan relay right above the radiator fan.
Your Renault 5 engine fan isn't kicking in Any idea why?
Dead fan motor, bad connetion to fan motor, faulty swith on radiator. To check, pull connetion to fan apart, this is a two spade connection found close to fan. Run a live wire from battery to connection and another wire from connection to negative pole on battery. If fan starts to spin, the motor is fine. This test can also be done at the thermostat switch on the radiator. Fault must be at radiator switch. This switch is located half way down the right hand side of the radiator. Drain radiator, remove switch, replace switch, refill radiator, bleed cooling system. Problem solved.
Where is the fan control module on 2003 Mazda mpv?
By the radiator fan on the battery side. Visible leaning over front bumper into engine bay looking back at radiator fan. Black box with several wire harness connections and two screws.
