0
It is a resistor that changes resistance based on temperature 0 volts is cold 13 volts pins the gauge. The difference between the one wire and the three wire is the three wire is not Dependant on battery voltage. the old ones will read colder at 11 volts than at 13 volts
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the temperature heat sensor on a 454 Chevy motor?
Were is the temperature heat sensoe on a 454 chevy motor.
Why does the heat gage of a 1995 Chevy Lumina 3100 engine Car show danger overheating when there is no problem with the engine?
Check actual engine temperature with a thermometer--if in acceptable range temperature sensor or gauge may be defective
Will a bad heat sensor cause your Chevy s10 blazer not to start?
A bad engine temp sensor can do that.
What are the symptoms of a bad temperature sensor for 01 Chevy Malibu?
loss of control over the air and heat
Where is heat sensor 2004 Chevy s-10 truck?
Assuming this is a 4.3L engine, the engine temp sensor is located between #1 and #3 spark plugs.
What does the heat-temperature sensor do for a car?
It helps the computer to judge how much fuel to allow in to the engine, it can also run the gauge on the dash
What causes heat light to stay on?
A faulty temperature sensor can cause the ECm to think your engine is overheating, this turning the heat light on constantly. You should make sure that your engine isn't in fact overheating though.
Does the engine temperature control the heat in the car?
The engine's thermostat controls the engine coolant temperature. The temperature control inside for the heater controls the cabin heat.
Where is the IAT sensor for a 2002 Jaguar X-Type?
If IAT = Indicated Air Temperature, under the front bumper, away from engine heat.
Does having the heat on reduce engine temperature?
yes it does reduce your heat temperature
Is LM35 heat or temperature sensor?
temperature sensor (−55°C to +150°C) but range varies for other variants
Why would crank sensor work after pouring water on it?
Sensor failure is often heat related , when crank sensors first start to go out they often have an intermittent failure when the engine is at full operating temperature. You are cooling the sensor with water.
