0
The fork fits around a smooth part of the gear assembly. As you shift the fork slides on a rod, meshing the turning gears in the correct place to go into the gears chosen. A bent or worn fork will cause the transmission not go completely into gear or only partially go in, wearing the gear teeth.
Wiki User
∙ 9y ago
Add your answer:
Earn +20 pts
What holds the clutch fork on a 1993 Chevrolet 1500 bellhouseing?
A 1993 does not have a clutch fork if it is a pick-up truck. It has an hydraulic slave cylinder.
You are looking for a diagram of clutch fork and pivot ball for a1994 Chevy 2500 diesel with a nv4500 5speed?
1994 still had fork and pivot ball on the 6.5 trubo and the nv 4500 trans, still lookin for a diagram
What holds the clutch fork on a 1976 Ford F-250?
A part called a clutch fork pivot holds the clutch fork on a 1976 Ford F-250. Another part near the clutch fork is the clutch flywheel.
Where is the location of the master slave cylinder on a 1994 Ford Escort?
it is attached to the bell housing and makes contact with the clutch fork.
How do you replace clutch fork on a 2000 Hyundai Accent?
Fork
How do you replace a clutch cable fork on an Escort 1.8 diesel?
To replace a clutch cable fork on an Escort 1.85 diesel, first lift the clutch pedal to release the adjuster mechanism. Pull the cable through and hook the clutch cable fork.
Why is the clutch on your jeep not disengaging?
Broken clutch cable or clutch pressure plate fork.
Clutch pedal staying in?
Broken clutch fork or hydraulic line if a hydraulic clutch.
Why does the clutch judder when cold?
If this happens when cold not when warm, check the clutch fork mechanism. It is attached to the clutch it looks like a long fork mechanism, grease it as it might be sticking when cold..
Why does your clutch go to the floor and not return with no leaks?
The piston has slipped off the fork or the fork is broken.
1994 Chevy k2500 just did clutch slave and master cylinders and wont engage why?
Just had same problem and replaced both also. Still not engaging. Thought I was going to have to replace clutch due to bad pressure plate. Took transmission off engine and the release fork for the clutch had worn through on the pivot point. This is a recurring problem from what I have searched. Has to be replaced and a ball pivot replaced also for the release fork. Both are dealer parts if you want the right parts for the job. Searched after market but ones I looked at did not meet the size I needed. Good luck.
How do you adjust the clutch petal on a 1988 Chevy truck with manual transmission so that it engages father away from the floor?
Ok, the adjustment rod that connects to your clutch fork, it has threads ,, all you do is take out the pin on the rod and push on the clutch fork till the rod comes out, i think on mine i had to tighten it to where the nut was closer to the clutch fork, if you adjust it too much it will be hard to put in because of the pressure plate firmness, i tightend mine to where its hard to put it back in , this got me to engage like in the middle of releasing the pedal, ,,,,that's how you do it ,, , and that's how i did it, good luck
