It sends a signal though one of you motors kill/stop switches and shuts the motor off.
I want to know the signal that immobilizer send to stop the car engine
This may be a problem with the immobilizer, the engine isn't disonnecting the immobilizer from the engine, i.e. stopping the engine from being started.
u cant the immobilizer is built into the engine mine went i had to keep inserting the key in and out of the ignition
buy a ford
The NISSAN Vehicle Immobilizer System will not allow the engine to start without the use of a registered key.
There would be no point in the car maker fitting an immobilizer that could be easily over-ridden.
No such thing.
It can as long as you have the ECM from the new engine and then you will need to get the module programmed to your immobilizer system if your 2001 GTI doesn't have an immobilizer system then no it won't work.
The engine immobilizer key switch is situated within the glove compartment. where in the glove compartment? there is only the light fixture.
The short answer is - you don't!! wouldn't be much of an immobilizer if it were easy to bypass. You need to either fix the fault which is causing the problem, OR send the engine ECU off to a specialist who can reprogram it to disable the immobilizer
first you rake the engine out then you sit on the steering wheel and blowdry the engine the curl it with a curler
Engine management light is coming up it is also known as engine electronics, electronic immobilizer light shown in owner's manual how can i cure it?