answersLogoWhite
Chevy Suburban
Chevy S-10
Chevy Blazer S-10

How does one replace a 1989 Chevy Suburban left front fender?


Top Answer
User Avatar
Wiki User
2015-07-16 18:15:35
2015-07-16 18:15:35

Open the hood, Un bolt the hood hinge,mark the bolt holes to insure propper alignment later, Support the hood ,Locate all the inner Fender bolts along the inside well of the truck, unbolt them, 1/2 or 9/16ths socket, open the drivers door, unbolt the fender bolts there, remove the lfet side section of the front grille, if one piece remove the whole grille, check for bolts in the grille area, remove the fender, reverse procedure to re-install, aligne the bolt holes and check the hood line gap with the passenger side, make sure the fender does not rub on the door when you close it, adjust as necessary.. tighten all bolts...

Open the hood, Un bolt the hood hinge,mark the bolt holes to insure propper alignment later, Support the hood ,Locate all the inner Fender bolts along the inside well of the truck, unbolt them, 1/2 or 9/16ths socket, open the drivers door, unbolt the fender bolts there, remove the lfet side section of the front grille, if one piece remove the whole grille, check for bolts in the grille area, remove the fender, reverse procedure to re-install, aligne the bolt holes and check the hood line gap with the passenger side, make sure the fender does not rub on the door when you close it, adjust as necessary.. tighten all bolts...

Related Questions

User Avatar

how i can removefront headrest for chevy suburban 2001

User Avatar

The amount of Freon that goes into a 1995 Chevy Suburban depends on whether or not their is just front AC or front and rear AC. If the Chevy Suburban on front AC only it takes 3.0 pounds of r134a Freon. If there is front and rear AC then it takes4.25 pounds of r134a Freon.

User Avatar

The 1999 Chevy Suburban camshaft sensor is located on the front of the engine. The camshaft sensor will be behind the front engine cover.

User Avatar

How do you replace passenger side fender on a 1998 pontiac bonneville se

User Avatar

If you remove the headlight assembly you will have access to the turn signal bulb.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.