This question is incomplete but I will offer some thought. The transmission filter purchased from the local auto parts store has a rubber gasket attached to the tube which sticks into a port on the underside of the body of the transmission. The factory original rubber gasket tends to remain inside the port. I was told that the gasket on the replacement filter could be removed and the original gasket could remain in place to seal the replacement filter. The factory original gasket appears to be an aluminum ring overlaid with rubber and would likely require a special tool to remove. My experience with this situation is very limited and perhaps someone with better knowledge can give a more professional answer or offer advice for removing the factory original gasket.
This is a completely separate issue from replacing the pan gasket.
The filter is located inside the transmission. Access is gained by removing the transmission fluid pan on the bottom of the transmission.
How many quarts of transmission fluid does a 2004 Taurus 3.0 OHV require when draining transmission and replacing filter
Inside the transmission. The pan on the bottom of the transmission must be removed to access the filter.Inside the transmission. The pan on the bottom of the transmission must be removed to access the filter.
Low transmission fuid level Transmission filter plugged? Transmission needs rebuild?
A quick check shows: $12, $18 & $29 (Motorcraft) See "Related Questions" below for more about transmission filter changing and fluids
inside the transmission.
yes it will fit...thay are all the axod trannys and any Taurus transmission will fit in any Taurus there is.
That is the cheapest repair solution to try.
Yes. They should both have the AX4S transmission.
where is the transmission speed sensor located on a 2005 ford taurus
The transmission fluid for the 2000-2004 Taurus is MERCON V.
There is no drain plug on this transmission.