answersLogoWhite

0


Best Answer

Very expensive and not worth the effort. If i was going to swap to tune port I'd do it on a 350. The modification adds between 40 or 50 horse

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: How hard is it to switch a tbi to tpi on a 1995 305 Chevy is it worth it?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is it hard to replace dimmer switch on a 2000 Chevy Monte Carlo?

Its pretty easy, as long as you have or have found a new switch. You just have to go to your local Chevy Dealer


Where are freeze plugs located on a 5.7 liter 1995 Chevy?

It can be hard to locate all of the little parts of a vehicle. The freeze plugs of a 1995 Chevy are located within the rear of the motor to the car.Ê


What makes noise on 1995 Chevy s10 with abs when press hard on brak?

That is the ABS in operation.


How do you change an ignition switch on a 1994 Chevy Caprice?

If you follow the instructions that come with the replacement it's not that hard.


How do you remove the ignition switch from a 1987 Chevy silverado?

rent a puller from auto zone!!! not hard at all!


How hard is it to replace the stoplight switch on a 1995 mercury grand marquis?

Not very hard. You have remove the panel that is under the dash. It should be a big black panel. The switch is on the brake pedal. Remove the two wires to the switch and unscrew it and replace it and reverse the order and you are done.


How do you replace a stop light switch on a 1995 Chevy work truck?

Get a new one and you will see that it is very simple to just slide it in bs. its hard to get your hands up there, you must be in a very weird position. and good luck getting the little keeper to stay on


For a Chevy truck how would you hard wire a start and kill switch fro starter to electronic ignition to the cab?

I have a 93 chevy pick up all I want is to hard wire the starter so the the truck will start with just wire straight from the starter to battery


Where is the oil sending unit located on a 1995 Chevy?

It is screewed into the top of the engine block right behind the distributor. It is HARD to see and to REMOVE.


Can you take the top off a 1995 Chevy blazer?

the s series blazers do not have removable hard tops. it is only the k5 blazers/ jimmys that have them


Where is the starter on a 1995 Chevy Caprice 5.7?

underneath pass side tword back of motor hard to miss if your lookin in the general area


1995 Chevy blazer brake pedal is hard?

Sometimes a piece of carbon will get caught in the EGR Valve. If is is hard starting, idles rough, and the brakes are hard, check the EGR Valve, it probably has a piece of carbon stuck, keeping it open.