Not very many if at all. Almost all of the newer models are self contained pre-greased units. All the places to look for fittings (if they are there) are: upper and lower ball joints, center of all four u-joints, and where tie rods meet each other. There are four fittings in my 95. That's about it.
On a 1990 there should be 3 on each side for the front & then one on each end of each drive shaft so total = 10.
SEVEN
none
11 grease fittings
There are no grease fittings on this vehicle. Many aftermarket parts do have them, though.
5. 2 Upper ball joints, 2 outer tie rods, and 1 trac bar.
each tie rod end and lower ball joint if they have be replaced
2 Grease Fittings. One on each Tie Rod End.
41
There are approximately 20 grease fittings in the regular car. However, it will vary depending on the make and model of the vehicle.
11
Geo Prizms have no grease fittings. All parts are sealed units and simply must be replaced when they wear out.
7