0
How many labor hours to replace a water pump on a Pontiac Grand am with a 2.4 liter engine?
Wiki User
∙ 13y ago
I just had mine replaced last fall and it cost me $800. I was told by the garage that did the work that they charge 7.5 hours for the labor. I paid $99 for the new pump $12 for a new seal kit for the timing chain housing and the rest was labor. 99 grand am's have an internal water pump that is located in the timing chain housing. If you do it yourself you will need a special forked tool to insert in the duel cam shafts so the don't turn when you release the tension on the timing chain which I didn't know at the time so that is why I paid to have it done.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How much labor time is required to install a thermostat in a Pontiac Grand Am 3.4 engine?
2 hours
What is the time for the labor to replace a piston and crank on a 2007 Pontiac grand prix?
Mitchell OnDemand estimates 14 hours.
How do you replace an oil pan for 2001 Pontiac grand prix?
You need to pull the engine, 6-8 hours, need a cherry picker to lift engine. Need to disconnect several parts (oem sway bars may need to be replaced because they often crack)
What numbers do you need to replace a stock radio in a 1999 Pontiac Grand Prix GTP?
I have a 2003 grand prix GT and the unlock code is 1040. use the hours and minutes and then press AM/FM. wait and it should work.
Where is the crank position sensor located on a 97 Pontiac Grand Prix SE 3.8L V6 and how difficult and expensive is it to replace?
It is located on the drivers side of the crankshaft pulley. The shop time to replace it is 1.4 hours and the part is about $80. It would be around $225 to have the dealer replace it.
Oil pan gasket on 1995 Pontiac grand prix Se?
how many hours to remove oil pan gasket 1995 Pontiac
How long does it take to replace the water pump on a 1992 Pontiac Firebird 305?
about 2 hours
How many labor hours to replace evaporator core in a pt cruiser?
labor hours to replace evaporators dodge grand caravan se 2009
Hard to steer Pontiac Grand Am 2000?
More than likely the rack and pinion on the car has blown the seals inside. but i would start with a power steering pump there about 25 30 dollars if that doesn't fix it get ready for the fun takes about two to three hours to replace the rack the engine frame has to be dropped down some to get it out but i have fixed several of those.
Is a 3300 V6 engine a good choice for a 1994 Pontiac Grand AM?
if you are looking to do an engine swap,it is a bad choice, the 3300 is from the 92-93 grand am and does not directly fit. the 3300 is a 90 degree V6 engine like the 3800,you are much better to go with the 3100 that is standard in any V6 grand am from 1994 till 1998. The 3100 is a 60 degree V6, as is the 3.4 engine in the more modern grand am. Even the 3400 could be a difficult job,if you are very mechanically inclined you could do a 3300 swap yourself, but i am told that it is about 100 hours labour to put the 3800 into a grand am and the 3300 would be a very similar job.
How long does it take to replace the motor 2006 Pontiac Montana v6 3.5 L?
The duration to replace the motor 2006 Pontiac Montana V6 3.5 L depends with the expertise and experience of the mechanic. IT may take at least 3 hours.
How many hours does it take to replace water pump in Dodge Intrepid?
2 hours to 7 hours, depends on the engine size.
