My mechanic is charging me 448.77 for parts and labor to replace it in a 2011 Kia Rio. Is this a fair price?
This part cost around $150. The price you are paying seems high to me. I would think $350 would be reasonable including an alignment. Get another estimate.
replace a control arm 99 tarus
no you do not have to remove the strut just take the lower control arm lose.
I just got mine done today. The dealer wanted 300 dollars. I took it to a friend's garage and it was 150.00
You cannot replace just the bushings. You have to replace the whole control arm.
For the lower ball joint, remove the lower control arm and the ball joint seal. Press the ball joint from the control arm. Press the new ball joint into the lower control arm ensuring it is fully seated, install a new seal and the lower control arm.
They would be connected to two control arms, one upper control arm and one lower control arm.
A bad lower control arm can cause the car to shake, wander, or be hard to steer. If the arm breaks or comes loose, then you will lose control and not be able to steer the vehicle.
How much does it cost to replace the upper and lower control arm bushings on a 1998 Chevrolet S-10? Upper control arm bushings are quoted at about 1.9 hours fro each side. However, if both are done then 3.5 hours total. Lower control arm bushings are 1.9 hours for one side and 3.4 hours for both sides. Just apply your shop's labor rate to the above hours. Note: Not all mechanics use the same book to estimate time for reapirs. This data is provided by Alldata. Mitchell Brothers could be different, as could the other services. Note 2: Upper control arm bushings are far easier to replace than lower control arm bushings because they are far more readily accessibly.
The lower control arm bushing would be located at the inner pivot point where the lower control arm is mounted to the frame/crossmember. Depending on your vehicle it could have one or two bushings. The outer pivot point would be your lower ball joint.
Me as a experience mechanic it could cost around 800
Detach lower ball joint from steering knuckle. Remove bolts that secure control arm to vehicle.
Not sure what part you are talking about because the lower control arm is connected to the frame. If you are talking about the long bar that's connected to the frame and the lower control arm, that is the torsion bar.