Mitsubishi Eclipse
Chevy Blazer S-10
Air Filters and Intake Manifolds
Timing Belts and Chains

How much does it cost at a dealer to replace the timing belt on a 2000 Mitsubishi V6 Eclipse?

121314

Top Answer
User Avatar
Wiki User
Answered
2005-12-01 06:35:56
2005-12-01 06:35:56

for a 95 eclipse it cost $399 parts and labor.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


The cost to replace the timing belt on a 2003 Mitsubishi Eclipse is about $700. This will depend on what else needs to be replaced and the dealer that you use.รŠ

Without the proper equipment you cannot replace the timing belt on your Mitsubishi Triton. The best place to have this work performed would be your local Mitsubishi dealer or at a trusted car repair business.

How do you replace the timing belt on a 2003 Mitsubishi Lancer?

take it to a macanic and if you area macanic you are not a very good one

go to www.autozone.com http://www.autozone.com/shopping/repairGuide.htm?pageId=0900c152800ad69e

go to autozone.com and go to vehicle repair guides

Remove the timing belt cover. There should be a pully that will ratched in and out to tighten and loosen the belt.

You need to remove the timing belt cover in order to gain access to it. If you want to replace it, timing belt has to be removed too.

what is the timing sequence on a 1994 Mitsubishi ecipes 2.0 leader no turbo??

It is best to replace the timing belt when the car starts approaching 100,000 miles. It starts to be dry rotted. It is a lot cheaper to do it before it goes out. If it goes it can cause a lot of damage to engine.

The Mitsubishi 2.4 liter engine timing marks can be found on the front of the main pulley. The timing marks will be scattered around the outside of the main pulley.

Crank position sensor is located next to the crankshaft. In order to replace it you might have to remove the timing belt. In the most models you just can remove remove the timing belt cover and replace the sensor.

How do you replace a timing belt on a Mitsubishi Endeavor 2004? (en francais si possible)Read more: http://wiki.answers.com/How_do_you_replace_a_timing_belt_on_a_Mitsubishi_Endeavor#ixzz1p65Hf8AS

Accoring to Mitsubishi every 5 years or 60,000 miles

drain the coolent remove timing belt.....loosen bolts....4g63, take off accessory belts and remove

It will take you approximately 6 hours, if you keep the timing marks in place. Also, consider replacing water pump at same time, it takes about 20 minutes longer to do it as you replace the timing belt.

http://www.vfaq.com/mods/timingbelt-2G-NT.html

THE TIMING BELT IN A 2002 ECLIPSE 3.0L GT IS LOACTED ON THE PASSENGER SIDE AND YOU WILL HAVE TO REMOVE THE BLACK PLASTIC GUARD'S TO REVEAL THE TIMING BELT AND CAM GEARS!

i have a 2004 Mitsubishi endeavor . i was wondering how often you would sugest replacing the timing belt .

It's behind the timing belt. Even so you do not need to remove the belt, you will have to remove the pulley and covers. If you want to replace it.

factory timing alignment marks for mitsibushi L 200 diesel

Need a diagram to set the timing Mitsubishi 1991 pu

Difficult to describe. It is next to the timing belt and is usually changed when you replace the timing belt


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.