0
How much does it cost to replace an intake gasket on a 2006 Chevrolet Equinox?
Wiki User
∙ 7y ago
Parts and labor aprox $600 to $700. It also depends on your location.
Wiki User
∙ 7y ago
Add your answer:
Earn +20 pts
Labor charge to replace a intake manifold gasket on a 99 Chevy Tahoe?
The labor charge to replace and intake manifold gasket, on a 1999 Chevrolet Tahoe, is approximately $180. It takes approximately 2 1/2 hours to replace the gasket.
Can antifreeze get into cylinder by way of intake gasket on a Chevrolet Equinox with a 34 engine?
They're all V-6's and yes it's possible to blow a head gasket but usually by overheating
What will cause coolant to get in oil head gasket or intake gasket?
The Intake gasket is leaking, NOT THE HEAD GASKET. Replace the intake gasket
How do you change the intake manifold gasket on a 1990 Chevrolet c1500 silverado?
remove the air filter pan assembly and the 15-20 intake bolts clean gasket area replace n re bolt down
How do you fix intake gasket on 2000 lasabre?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
What causes a Chevrolet 350 motor to have antifreeze on intake?
Probably a gasket leak. Could be the intake gaskets or the thermostat gasket.
Can you use a sealer to fix the intake gasket leak?
NO. You MUST replace the intake gasket.
Do you have to replace the intake gasket when removing intake manifold?
Yes, you must install a new intake manifold gasket.
Intake manifold gasket leak?
Replace gasket why does gasket keep sliding
How much does it cost to replace intake manifold gasket on Chevrolet venture van?
I found an independant mechanic, who works out of his own building on a farm, who does this for about $375
How do you replace the lower intake manifold gasket in a 99 Chevy Venture?
there is no lower intake gasket, only a front and rear gasket
Is there anything you can do to prevent coolant from leaking into the engine of a 1998 Chevrolet Malibu 3.1 V6 after replacing the intake gasket a year ago?
The intake manifold are very bad about corroding a hole in them which means that you will have to replace it.
