Should cost 400-600 in labour 300 for the part.
You must separate transmission from engine. Then the throw out bearing is located on a fork by where tranny attaches to engine. Remove bearing, pack grease into new one, install in reverse order of removing old bearing. You might as well change clutch and pressure plate. Install tranny to engine.
Remove driveshaft. Remove transfer case if you have 4X drive. Support engine. Remove transmission. Replace clutch. Reverse procedure to install. This is a big job and you will need a good step by step manual. Read this: http://free-auto-repair-advice.blogspot.com/2007/11/finding-repair-information-you-need-at.html
Yes, the car was exactly the sam for those years. Usually, the car parts comply until they change the body style completley. Or, buy a universal automatic window regulator. Patrick
Remove the water supply lines from your 1990 Ford E3 50 heater core. Remove the heater core retaining bolts. Reverse the process to install your new heater core.
Just replace it, it's not expensive.
just replace the engine with a 4 or 6 cylinder and your done.
im sure this is on the clutch pedal itself.
The slave clutch cylinder on a 1994 Honda Civic is located inside the engine compartment. On the driver-side close the firewall. The clutch fluid should be drained. Remove the mounting bolts and clutch lines to replace the slave clutch cylinder.
you buy one or take it to the shop
the fan clutch is built into the water pump,it cant be separated,you have to replace the water pump.
how to install and replace a rack and pinion on Honda accord 1994 lx
Refer to this: http://home.comcast.net/~mmunoz70/z/leskatimingbelt.doc
A diagram to replace the clutch in a 1994 Mazda B3000 is available in how-to books at most major auto parts stores. These types of manuals are also available at major book stores.
The part tat goes where the tramison
How to install thermostat in a 1994 volkswagen golf?
you will need to remove either the engine or the transmission(engine is easiest in the 94 escorts) replace the clutch and put the engine back in
answerremove 2 bolts and a cotter pin in the pedal,remove reservoir,unscrew fluid pipe,install new one,bleed clutch very well