0
Remove driveshaft. Remove transfer case if you have 4X drive. Support engine. Remove transmission. Replace clutch. Reverse procedure to install.
This is a big job and you will need a good step by step manual.
Read this:
http://free-auto-repair-advice.blogspot.com/2007/11/finding-repair-information-you-need-at.html
What else can I help you with?
How much does it cost to replace and install a new clutch disc on a 1994 ford probe gt?
Should cost 400-600 in labour 300 for the part.
Why does my 1994 ford ranger front wheels lean inward?
The front wheels on a 1994 Ford Ranger lean inward due to the camber of the steering alignment. Adjustments can be made at a local tire shop.
Where is the oil separator on a 1994 ford ranger?
underneth the intake underneth the intake
What is the transmission bolt torque for a 1994 Ford Ranger?
it is a manual 5 speed tranny.
Where do you put the clutch fluid in for a 1988 ford ranger What does the reservoir look like?
Should be on firewall next to master cylinder
How do you Remove clutch interlock switch on ford ranger?
How to replace a clutch interlock switch on a 1997 Ford Ranger XLT
Where do you put the clutch fluid in a 1994 ford ranger?
changing clutch in 1994 ford ranger ===================================================================== If it is like the ( 1996 ) Ford Ranger The clutch fluid reservoir is in the engine compartment , it is between the Power Distribution Box and the drivers side fender , It takes DOT 3 brake fluid
Should you replace the slave cylinder when you replace the clutch in a 1994 ford ranger?
Not if it is working alright. however if you suspect its the worst for wear it would be a good idea,
How do you change a 1993 Ford Ranger clutch?
how to i change a clutch in a 1993 ford ranger
Location of clutch slave cylinder of 1994 ford ranger?
The hydraulic clutch slave cylinder is inside the manual transmission bellhousing
How do you bleed the clutch line on a 2004 ford ranger edge?
how do I bleed the clutch system in a 2004 ford ranger
Does the transmission of a 1994 ford ranger 2.3l have to be removed to replace the slave cylinder?
yes
What kind of hydraulic fluid do you put in your Ford Ranger 2.3 for the clutch?
DOT ( 3 ) brake fluid is used for the hydraulic clutch in a Ford Ranger
How do you replace the clutch on a 2001 Ford Ranger?
get a book! you have to drop the transmission which isn't a whole lot of fun then unbolt the old clutch assembly and install a new one
How do you replace a Ford Ranger clutch?
You're gonna hafta drop the entire tranny to get to the clutch, pressure plate, and even tho throwout bearing/ slave cylinder.
Leak in the cab of your 1991 Ford Ranger coming from the clutch What should you doshould you replace the entire clutch or is it just the line?
Replace clutch master cylinder and bleed system,also check your slave cylinder for leaks.its bolted to your transmission,the clutch cable is connected to it.
My 1990 ford ranger will not shift into gear?
A 1990 Ford Ranger may not shift into gear if the clutch is out. A clutch can be purchased at any auto parts store.
