Winchester Firearms
Synonyms and Antonyms
Microsoft Xbox
Microsoft Xbox 360

How much is a Winchester 3030 model 94pre64 round barrel 19 inches long hardly ever used?


Top Answer
User Avatar
Wiki User
2005-10-14 03:04:16
2005-10-14 03:04:16

1940 to 1964 production standard carbine with no saddle ring From $150 to $395 depending on condition Blue Book of Gun Values


Related Questions

The trapper model is a short barreled model 1894 rifle.The barrel length was originally 16 inches,but under recent laws the barrel length is 18.5 inches.

Very little, and possibly worth 10-years ina federal prison and a $250,000 fine if it is found to be any fractional bit less than 18-inches. Winchester never made a Model 97 with an 18-inch barrel, so what you have is a non-factory cut-down gun. The shortest barrel length made by Winchester was 20-inches.

If that barrel is less than 16 inches long and you are in the US, you have an illegal firearm.

Winchester Model 67 is a single shot, bolt action, .22 caliber rifle. It was produced and sold between 1934 to 1963. It has a weight of 5 lbs, barrel length 27 inches.

If you mean the legal length of the barrel? it is 18 inches and for rifles it is 16 inches.

Not a State law- but a Federal law- the National Firearms Act of 1934- requires that a rifle that has a barrel less than 16 inches, or an overall length of less than 26 inches, must be registered as a "short barreled rifle" with the BATFE, and a transfer tax ($200) be paid for it. There ARE exceptions- rifles such as the Winchester Trapper Model with a 14 inch barrel is specifically exempted from this law.

With rifles and pistols, it is the diameter of the inside of the barrel in inches. So a .45 caliber pistol has a barrel 0.45 inches in diameter. In can also be expressed in metric terms- caliber 9mm means a barrel that is 9mm in diameter. With cannon, such as those on a Naval vessel, it is the relation of the barrel length to the internal barrel diameter- so a 3 inch 50 caliber cannon fires a shell 3 inches wide, from a barrel 150 inches long (3x50).

10.6 or 10.75 inches with a six inch barrel, depending on Mark, 14.75 inches with a 10 inch barrel.

A 570 gallon barrel that is 14 inches wide holds 570 gallons of fluid.

Federal law mandates a minimum length of 18 inches for the barrel.

A Jack Daniels whiskey barrel is 35 inches tall.

The Thompson Center hawken that I have,has a barrel that is 28 inches long.

Which pistol? Most production pistols have a barrel length of 1 to 8 inches.

30 inches. A longer barrel gives you better accuracy.

Yes it is 2 5/8 inches and that is considered a big barrel bat.

About 3 inches at the barrel.

It can be, depending on the action the gun uses. It can also be illegal if you cut the barrel length below the legal limit. In the US, a Title 1 rifle must have a minimum barrel length of 16 inches, and a Title I shotgun must have a minimum barrel length of 18 inches.

If it has a good bore, is all original and in good shape,I will pay you $500.00 for it. DON

Yes, only about 5-6 inches though.

7.35 cubic feet or 12,705 cubic inches

The value will depend on the condition. Pre-64 sporting rifles can run from $200 to $3000, depending on the condition. You would be best off having an advanced Winchester collector or gunsmith provide a professional appraisal of the rifle.

If you don't know the calculation, then how about you just use a kitchen measuring jug to fill the barrel and then you will know exactly how much water you have in there.

The maximum barrel diameter of a bat in the Major Leagues is 2 3/4 inches.

Measured from the breech to the crown of the barrel, it must measure at least 18 inches.

The legal minimum length of a non-rifled gun barrel in the united states is 7 inches.

Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.