There is no simple answer to this question.
The resistance/current varies in several parameters. Heat, lean/rich mixture, amount of contamination, etc. The value also varies from one manufacturer to another.
If you want bench test the unit, you must induce heat on the tip. Commonly with a propane torch.
If I understand the intent of your question; it is to replace the sensor with a $0.99 resistor.
This will not work as the value of the sensor changes many times a second.
The only fix is to replace it. If you are mechanicly inclined, this is a doable deal. Before you replace the sensor you should check the wiring for resistance you can use a volt/ohms meter (vom) and test the continuity of the wiring to the sensor.
Just got the info. The resistance for the ABS sensors is 750 ohms to 1400 ohms (Max.)
x1 is single ohms. If the dial reads 40, the resistance is 40 ohms.
how much resistance must be connected in series with a 250 ohms inductive reactance to produce a total ciruit impedance of 400 ohms?
The wattage and ohms of a speaker are not related; the resistance for speakers is usually 4 or 8 ohms.
The number of ohms is, precisely, the value of the resistance.
An ohm is a unit of electrical resistance. A kilohm is 1,000 ohms resistance, while a megohm is 1,000,000 ohms resistance.
Just use Ohms Law: V=IR, that is, voltage (in Volt) = current (in Ampere) x resistance (in Ohms).
10.2 kilo ohms is the resistance necessary for 1 volt to induce a current of 98.04 micro amperes. Ohm's law: voltage equals current times resistance.
Electrical resistance (and impedance) is measured in ohms(Ω).
If they're connected in series the total resistance is 2000 ohms. If they're connected in parallel the resistance is 500 ohms.
5,672 Ohms at half-way open...good luck!