If the work is to be done by Saturn, Expect to Pay between $1100.00 and $1250.00
I am doing the same project, just picked up the headgasket and headbolts from O'Reilly for $42. I'm waiting to see how bad the intake and exhaust manifold gaskets are before I spend the $7apiece for new ones. I'm broke, lookin to do this as cheap as possible. lol
If your cooling system is full of oil, you'll need to flush the system VERY well with a mild detergent, and then TONS of water to get all the remaining oil and detergent out. If you have oil in the cooling system, Saturn will tell you to replace your radiator/hoses/waterpump. I am not doing this, just am flushing the system throughly. I have done many headgaskets before, and have never had any adverse results from not replacing radiator/hoses/waterpump.
Once you have the cylinder head off, that needs to be planed or resurfaced, to make sure your new gasket will seal properly. This costs $40+tax at engine shops here in WI.
After buying new oil, coolant, the gasket(s), and headbolts, plus the cost to resurface the head, I'll be getting this done for somewhere around $160-$225.
If this is your first time replacing a headgasket, this would be the motor to do it on. The 1.9L single cam is easy to work on, and there's not much to get in your way or make things difficult.
Best of luck!
The only repair for a blown head gasket is to replace the gasket.
Unless the housing is damaged, there is no reason to replace it. Just replace the gasket.
One hour of labor (~$75) + the gasket (~$15-25).
YES BUT. YOU SHOULD USE THE 1996 CRANKSHAFT AND THE 1996 INTAKE SO YOU NEED TO DISASEMBLE BOTH ENGINE TO DO ONE
a blown head gasket needs to be replaced as early as possable. it will only get worse and additives like water glass, etc will gradually worsen the problem.
A 1996 Saturn vehicle will only use R134A refrigerant. I was a Saturn technician for years in Saturn Dealerships.
.....what about it? There is one. Dealer has premolded ones also
yes you can replace the head gasket. you can on all engines. you just gotta take the head off
I believe the engine has to come out and the block has to be opened up because the head gasket is in the center
If that is the Northstar engine, yes.
Call an Auto Zone store and ask for the machanical schematics of the car and also the step by step papers on how to take of and replace the head gasket.
To be fair: about 4 hours. I charge $240.00 labor to do that job.