0
How much should these items cost for a 1993 Chevy corsica 'ABS control unit' 'ABS hydraulic assembly' 'ABS Pump and Motor Assembly' 'ABS speed sensor?
Wiki User
∙ 17y ago
Average Prices Should Be As Follows: ABS Unit : $277.97 ABS Hydraulic Assembly: $478.79 ABS Pump & Motor Assembly: $227.79 ABS Speed Sensor Left: $ 68.79 ABS Speed Sensor Right: $ 81.79 Total $1135.13 Sales Tax (8.25%) $93.64 Overall Total $1228.77* *Parts Only, Price Excludes Labor
Wiki User
∙ 17y ago
Add your answer:
Earn +20 pts
How do you replace rear turn signal bulb on 1995 Corsica?
Open the trunk, look for some plastic nuts, remove these and remove your rear lens assembly; remove sockets from assembly.
How do you change a tail light on a 1995 Chevy Corsica?
you need to remove the taillight assembly. you will see all the bulbs.
Need a photo of the rear brake assembly on a 1989 Chevy Corsica?
Take the drum off and take a picture. Use one wheel as a guide to repair the other.
The blow motor was not working on your 94 Corsica and when I grounded it it took out the blower motor and the radio. Is there a circuit or relay for both?
You most likely blew a fuse and have a bad blower motor resistor assembly
If the tension pulley is bad on a 91 2.2 l Corsica can one just replace the pulley or must one replace the entire assembly?
Call the parts store. They will be able to tell you if the pulley is available separately or not.
Where is the ingnition coil on 1991 Chevy Corsica 4-cylinder?
If you have the 3.1L V6, you will find all three coils mounted to the ignition module on the left side of the engine block (front of car side) directly below the exhaust manifold. Remove the air cleaner assembly, then electric cooling fan to see them. Use a 10mm socket on three mounting bolts to remove the entire assembly from the engine block.
Do you need to bleed brakes on a 95 corsica when you change brake pads?
normally you shouldn't have to,unless you've disturbed the hydraulic side of them
How do you you replace the ignition control module for 1993 Chevy Corsica?
GM Corsica/Beretta 1988-1996 Repair Guide1993 Chevrolet Corsica 2.2L SFI OHV 4cylControl Module-Ignition:Located under hood, driver side, rear engine area, under exhaust manifold, mounted under ignition coil packRemoval & Installation:# Disconnect the negative battery cable. # Detach the 8 or 11-pin harness connector from the coil and module assembly. # Remove the ignition assembly-to-camshaft housing attaching bolts. # Carefully remove the ignition assembly from the engine.If the spark plug boots present a problem coming off, it may be necessary to use a special removal tool, first twisting and pulling upward on the retainers.# Remove the ignition coil housing-to-cover bolts/screws. # Remove the cover from the coil housing. # Unplug the coil harness connector from the module. # Remove the screws attaching the module to the ignition assembly cover.If the same module is going to be replaced, take care not to remove the grease from the module or coil. If a new module is to be installed, a package of silicone grease will be included with it. This grease aids in preventing the module from overheating.To install:# Place the module on the ignition cover and install the attaching bolts/screws. Tighten the attaching bolts/screws to 35 inch lbs. (4 Nm). # Connect the coil harness connector to the module. # Assemble the module cover to the coil housing and install the attaching bolts. Tighten the attaching bolts to 35 inch lbs. (4 Nm). # Install the spark plug boots and retainers on the ignition assembly housing secondary terminals.If the boots and retainers are not in place on the housing secondary terminals prior to installing the ignition assembly, damage to the ignition system may result.# Position the ignition assembly to the engine while carefully aligning the boots to the spark plug terminals. # Coat the ignition assembly-to-camshaft housing attaching bolts with an approved lubricant and install them into the housing. # Tighten the attaching bolts to 16-19 ft. lbs. (22-26 Nm). # Attach the harness connector to the ignition coil module assembly. # Connect the negative battery cable. # Start the engine and check for proper operation and performance.
What 3 islands did Carthage have under control?
Corsica, Sardinia, Sicily.
Which important Mediterranean island was under French control by 1800?
Corsica
Where is the heater fan located in a 1991 corsica?
That model is under hood on the passenger side of the car. The motor is a black, circular piece about 4" in diameter. Remove the 6 or so small screws and the 2 wires and the assembly should come right out. I hope this helps you. Mark
Where is the distributor for a Corsica 1993?
there is no distributor. it uses coil packs and control modules
