One reason that the pull cord on a Weed Eater Blower may have become stuck is because the spring broke. You can try to take it apart to fix it, but it can be difficult. The best option is to bring it into a repair shop.
repair the pull start ?
take off the part containing the pull start and retie on another string fed throu the hole and tie on the handle.
1. put the carb into start position 2. Pull cord 3.put into run position 4. pull throttle. BTW you might want to ad gas! and if you still dont know how to run this then WOW your special
Try to start the engine. If it's electric start, it will be reluctant to start, or not do anything, usually make squealing noises. If it's pull-start, it usually is a lot harder to pull, and won't react much to any pulling at all.
if you mean gas as in petroleum they are just like a weed eater, prime them then pull the starter cord until they turn over. A nitro RC has many different ways, some use pull starts others have the traxxas easy start system or the hpi roto start and some use starter boxes that physically turn the engine.
Pull start only
how much to pull a tooth
i don't think you can you will need to bye a new pull start or pull the cover of and find a piece of line that will go around the pully so you can start it
The incredi pull design is defective. Obviously there was no quality assurance. The pull line will wear through the small plastic choke idlers and render the entire trimmer useless once it has worn about halfway through.
No, the engine does not have to be removed, but the transmission does. Cost, depends very much on where you live. Get estimates.
i have an 05 it is electric and pull start